Panasonic CQ-C3305N Operating Instructions Manual

Contents

CQ-C3305N10 CQ-C3305N 11 EnglishGeneralGeneralThis chapter explains how to turn on or off the power, how to adjust the volume, etc.Power onPress [PWR] (Power).Power offHold down [PWR] (Power) for 1 sec. ormore.You can remove the face plate toprevent it from being stolen.Removing1 Turn off the power. ( above)2 Press [OPEN]. The face plate will beopened.3 Push the face plate tothe left.4 Pull it out toward you.5 Put the face plate inthe case.Cautions• This face plate is not waterproof. Do not expose it towater or excessive moisture.• Do not remove the face plate while driving your car.• Do not place the face plate on the dashboard ornearby areas where the temperature rises to high.• Do not touch the contacts on the face plate or onthe main unit, since this may result in poor electricalcontacts.• If dirt or other foreign substances get on thecontacts, wipe them off with clean and dry cloth.• To avoid damaging the face plate, do not push itdown or place objects on it while it is open.Power On/off(PWR: Power)Face Plate Removing/Mounting(Anti-Theft System)Display Change(DISP: Display)The display changes as follows every time [DISP] ispressed. (ACC ON)At power-off:Clock display (Default)Display offMounting1 Fit the face plate with its left hole on theleft pin provided on the main unit.2 Fit the other hole on the other pinapplying slight pressure.At power-on:When the power is set to ON, refer to the description foreach source mode.Volume off (down)Press [MUTE].CancelPress [MUTE] again.Note: You can select mute or attenuation. ( page 27) Up DownSetting Range: 0 to 40Default: 18Note: The volume level can be set independently foreach source. (For radio, one volume setting for AM(LW/MW), one volume setting for all FMs)Volume Adjustment(VOLUME)Temporary Volume Off(Down)MUTE (ATT: Attenuation)Caution• Set the volume level to low enough before theAUX connection is completed.Failure to observe this, the loud noise may comeout and damage your speakers and your hearing.The source changes as follows every time [SOURCE]is pressed.AUX1 (AUX1 in) (3.5 mm  stereo)From line output of external sound/audio device (ex.Silicon-audio player, HDD player, etc.)RadioFM1, FM2, FM3, AM ( page 12)PlayerWhen loading CD ( page 18)When loading MP3/WMA disc ( page 20)AUX1Device connected to the AUX1 terminal of this unitWhen an optional device is connected:Shift to connected deviceWhen connecting CD changerWhen connecting iPodORWhen an expansion module is connected:The devices connected to the ports 1 to 4 areactivated in sequence after shifting to AUX2 (deviceconnected to the AUX terminal of the expansionmodule).Note: For information about connectable devices,refer to the System Upgrade Guidebook or theinstruction manual for each device.System-up ConnectorSource Selection(SOURCE)