Panasonic CQ-C8301N Operating Instructions Manual

Also see for CQ-C7301N: Service manual

Contents

Preparation EnglishCQ-C8351N/C8301N/C7301N 1110PreparationCQ-C8351N/C8301N/C7301NNote:¡ Adjust the clock when “NO CT” appears on the dis-play.¡ When a broadcast of FM Radio Data System isreceived, the clock is put right automatically by theClock Time service. (a page 20)1 Press [MENU] to display the menudisplay.For using the remote control, hold down [SEL](MENU) for 2 sec. or more.2 Press []] or [[] to display theDISPLAY menu.3 Press [{] to select “CLOCK ADJ”.4 Press [BAND] (SET) to confirm thedisplay.5 Adjust the setting value.[[]: Adjusting minutes[]]: Adjusting hours[}]: Forward[{]: Backward6 Press [BAND] (SET) to confirm theadjustment.Note: For cancellation of clock adjustment, press [DISP].7 Press [MENU].For using the remote control, hold down [SEL](MENU) for 2 sec. or more.The demonstration message appears for first use.1 Set your car's ignition switch to the ACCor On position.2 Press [SRC] (PWR: POWER).The demonstration screen appears.3 Press [DISP: DISPLAY].The demonstration screen is cancelled, and no moreappears.Note: If you would like to turn on the power and makethe demonstration message appear, hold down [SRC](PWR: POWER) for 4 sec. or more. (at ACC onsetting)You may need to set the following depending on thedevices to be connected.Using Subwoofer¡ Subwoofer level adjustment (a page 34)¡ Subwoofer low pass filter (a page 34)The following functions are activated when the SecurityFunction is ON. (a page 35)¡ The security indicator lights up when removing theface plate.¡ The alarm sounds and the message appears on thescreen to warn you to remove the face plate at ACCoff.Security IndicatorAFSRCPTYCQ-C8301NSQTAFirst Time Power On(DEMONSTRATION)Remote Control PreparationSecurity FunctionSettingOther SettingsClock adjustment(CLOCK ADJ: CLOCK ADJUSTMENT)WarningKeep batteries and insulation film out of reach ofinfants. If an infant ingests a battery, please seekimmediate medical attention.Cautions¡Remove and dispose of an old battery immediately.¡Do not disassemble, heat or short a battery. Do notthrow a battery into a fire or water.¡Follow local regulations when disposing of a battery.¡Improper use of a battery may cause overheating, anexplosion or ignition, resulting in injury or a fire.Note: Battery Information:Battery Type: Panasonic lithium battery (CR2025)(Included in the remote control)Battery Life: Approximately 6 months under normal use(at room temperature)Preparation Before Initial UsePull the insulation film outfrom the backside ofremote control gently.Battery Replacementqwq Remove the battery holderwith the remote control unitplaced on a flat surface.q Stick your thumbnail intothe groove, and push theholder in the direction ofthe arrow, and at thesame time.w Pull it out in the directionof the arrow using atough pointed object.23w Put a battery in the casewith (+) side facing up.e Put the case back.Tough pointed objectBack sideACC SettingOFFACCIGNFor a ACC-equipped car, select ON. (a page 35) Thefollowing functions are available. (default: off)¡ The power is turned on automatically when inserting adisc or magazine.¡ The clock can be displayed even if the power is off.(a page 15)SRCInsulation filmCautionBe sure to select OFF when your car has noACC position in the ignition switch. Failureto do this could cause the battery to godead.