Panasonic CQ-VA7300N Operating Instructions Manual

Contents

Panasonic CQ-VA7300N Operating Instructions Manual Manual pdf 7 page image

1311ENGLISH12ENGLISHCQ-VA7300N CQ-VA7300N12PWRMODECH 114TAAFLOCENTERMUTELOUDVOLUMECAR AVNAVINAVIGATIONSCROLLDISPASPECTMENUP·MODEPTY5623RANDOM SCANREPEATCH 214LOCENTER5623AFRadioMONO: Noise is significantly decreased when weak signals are received from an FM broadcast station.LOCAL: Only strong signals of stations are searched for in seek tuning, while at the LOCAL OFF setting, relatively weaksignals are also searched for.e Manual Tuning[[]: Higher frequency[]]: Lower frequencySeek TuningPress and hold for more than 0.5 seconds thenrelease.[[]: Higher frequency[]]: Lower frequencyTuning will automatically stop when the signalsof the next broadcast station are received.w BandPress [ENTER] to change the band.q Radio ModePress [MODE] to change to the AM/FM(LW/MW) mode.Sub-LCD Display (at monitor close)[LOC] (Local)[1] - [6] (Preset)[MODE]MONO OFFMONO ONMonaural Mode [Default: MONO OFF]Press and hold [AF] to switch the MONO mode onand off.LOCAL OFFLOCAL ONLocal Mode [Default: LOCAL OFF]Press [LOC] (Local) to switch the LOCAL mode onand off. (Only for remote control)Mono/Local Selection (MONO/LOC)Note: The stereo indi-cator lights duringreception of an FMstereo broadcast.FM1FM2FM3AMStation PresetUp to 6 stations each can be saved in the FM1, FM2, FM3 and AM preset station memories.Perform these operations with the remote control.Manual PresetMemoryManually save a station in thepreset memory.Select a band and frequency. (step w and e on the previous page)Press and hold [1] to [6] for more than 2 seconds.The frequency blinks once, anda receiving station is saved inthe memory.Auto PresetMemoryAutomatically save stations withgood reception in the presetmemory.¡The 6 stations with good reception will be automatically saved in thememory under preset numbers 1 to 6.¡Once set, the preset stations are sequentially scanned for 5 secondseach.¡To stop the scanning, press [1] to [6].Note: Only RDS stations will be saved at default setting (AF ON). To selectnon RDS stations too, set AF OFF. (a page 15)Select a band. (step w on the previous page)Press and hold [ENTER] for more than 2 seconds.Preset StationCallingSelect a band. (step w on the previous page)Press [1] to [6].Note: You can call up preset stations 1 to 6 by pressing [{] and [}]on the display unit as well.Note: New stations overwrite existing saved stations after following this procedure.[]][[] (Tune)[ENTER] (Band)[AF][]][[]VOLVOLVOLNAVINAVIGATIONASPASPECTTILTMUTEMUTEMUTEDISPPTYTA AFMONO/STENTERMODEPOWERMENUEON PTY CTIN-DASH 7 INCH COLOR LCD MONITOR WITH RECEIVERCQ-VA7300NLOUDTRACKTUNEPRESET / DISCOPEN / CLOSECQ-VA7300NASPECT TILTENTERMODEAF[ENTER](Band)[MODE][AF]PTY DisplayBand Preset number“Sub-LCD Display Change” (a page 38)FrequencyMode Display FM Stereo IndicatorBand/frequency[] ] [[ ] (Tune)[{] [}] (Preset)