ENGLISH15Timer setting / Sleep Timer ModeSetting the TimerOnce the appointed time is set, the unit will start tooperate automatically everyday on the set time. Thetimer operates on a combination of 2 settings: “TIMERON” and “TIMER OFF”. You must confirm andsynchronize it to the current time. The timer will notoperate when the time display is blinking. To canceloperations The indoor unit's timer lamp remains on even afteroperation has been stopped by the OFF Timer. When the timer is set, the current time indication will be off. When the timer is off and the operation has stopped, thetimer lamp on the indoor unit remains on.(The timer lamp will only be off when the timer cancelationis selected) When the timer is on, the operation will start on the timeset. It is advisable to set it to operate earlier than the desiredtime to allow it to reach the set temperature. (Maximum 1hour before) When this timer setting mode is used concurrently with thesleep timer mode, the sleep timer mode will be given thepriority. (After the sleep timer mode has stopped operating,the appointed time will again be displayed)Sleep timer Mode operationIt will stop the unit's operations after the presettime.IN OPERATIONSPressRemaining time being displayed(1 hour time blocks) When the 5 hour or 7 hour modes are selected, the settemperature will change as follows.Select the appropriatetimer using orbuttons then pressSleep timer modeoff button1 SelectorRemote controldisplay panel2 To select the appointedtime Blocks of 10 minutesare shown each time it is pressed.Continuously pressing either button will fastforward or reverse the displayed timeblocks. 12 midnight will be displayed as .3 PressTimer lamp (Orange)Timer settingbutton1 2 3 75Remote controldisplay panel Continuously pressingSelect the time while the time blockschanges in the display.(Cancel)Timer lamp (Orange)COOLING • DRY after 3 hours; increase by approximately 2°CHEATING after 4 hours; decrease by approximately 4°CRecommended to use this mode: Saving on electricity during sleep is required. To prevent wastage of electricity, use sleep mode whensleeping or Timer when going out.