16Odour wash modeOdour Clear operationsDuring repeated cycles of cooling and dry operations, odours from the carpets, odours from household fittings and odours from theliving environment will accumulate in the internal of the air conditioner. The odour will permeate from the unit together with the airflow. The “ODOUR WASH” oepration is used to remove those odours, to prevent them from permeating together with the airflowduring the air conditioner operations and to control the growth of odour causing moulds in the air conditioner’s interior section.EFFICIENT USE OF “ODOUR WASH” MODEODOUR CLEAROPERATIONBlowing out allaccumulated odoursTimer setting of ODOUR CLEAR OPERATION• ODOUR REMOVINGEveryday, the air conditioner's interior section will be dehumidified to prevent growth of moulds.Everyday, the air conditioner's air outflow will be delayed to prevent odour permeation.HEATING DRY • COOLING SEASONSBlowing out all accumulated odours during the “air circulation” and “heating” modes.Odour wash mode lamp(Green) blinksReturns to originalcondition after 20 minutesOdour removing operationsWith one time setting, whenever the cooling or drying modes start operating, the air outflow will be stopped for 40seconds to allow the clearing of odour wash. Air outflow will resume after this.DRY • COOLING IN OPERATIONS(The remote control does not display this) TO CANCEL THE MODEPress once more the button.(During operation, the odour wash modelamp (Green) is off)Odour wash mode lamp(Green) is onNOTE After the odour clear operation has ended, the Timer setting of odour clear operation mode will be set automatically. During setting of the timer setting of odour clear operation, you cannot oferride or cancel it. (The signal to cancel it will notbe accepted by the unit. There is a “Beep, Beep, Beep, Beep” audio response.) During operations, there will be a repeated cycle of air blowing out and air stop blowing out. It is recommended that you use this mode during the cooling • dry seasons, to prevent accumulation of odours. During the heating or air circulation modes, even if the odour removing mode is set, it will not operate. (The odour washmode lamp (Green) is off) Even if the odour wash mode lamp is off and the dry • cooling fan speed is in automatic mode, the odour removing modeis operational.(During starting of operation, the air outflow is stopped for approximately 40 seconds)HEATINGPress for 3 ~5 seconds.To set it by pressing itcontinuously for 6 seconds. To set it by pressing itcontinuously for 6 seconds. Press for 3 ~5 seconds.ODOUR CLEAROPERATIONBlowing out allaccumulated odoursPress the button for 3 ~ 5 seconds only.Press( )(There is no harmful effect if it stop operating halfway through)(The remote control does not display this) It will automatically stop after approximately20 minutes of operations (AIR CIRUCULATION →HEATING → AIR CIRCULATION)after which, the ODOUR removing will be set. IF IT STOP OPERATINGHALFWAY THROUGHPress