Panasonic CS-ME 7CKPGCS-ME10CKPG Operating Instructions Manual

ENGLISH17Timer setting of “odour clear” operationTo prevent the growth of mould in the internal section of the air conditioner, the internal sections may be dehumidified via the aircirculation / heating operations.With a one time setting, the odour clear operation becomes operational on the preset time every day. (Maximum duration: 50minutes)Please confirm and synchronize with the current time. When the time display is blinking, setting is not possible.123Press the button for 6 seconds and above,until “ODOUR CLEAR” appears on the remotecontrol display panel.Press to preset the time Blocks of 10 minutes are shown each time it is pressed.Continuously pressing either button will fast forward orreverse the displayed time blocks. 12 midnight will be displayed as .Press When the “ODOUR CLEAR” appears on the display panelof the remote control, “ODOUR REMOVING” is also beingset at the same time. The operation will start on the preset time and willautomatically end after approximately 50 minutes ofoperation, and will return to the original condition.Remote controldisplay panelOdour wash mode lamp(Green) is on.on the preset time TO CANCEL THE MODE1 Press the button for 6 seconds and above only. “ODOUR CLEAR” appears in the remote control display panel.2 Press The odour wash lamp in the indoor unit and odour clear indication in the remote control are disappeared.NOTE The “TIMER” can not be set at the same time. If this mode is set when the “TIMER” mode is still active, it will overrideand cancel the “TIMER” mode. (The indoor unit’s timer lamp will be off) however, the other indoor units that are beingconnected to the common outdoor unit, will not be affected and their “TIMER” modes can not be cancelled. Indoor units having the “Timer setting of odour clear operation” mode set, can not operate on “TIMER” mode. (Even ifthe “TIMER” mode is active, the signal to cancel will not be accepted by the unit. There will be “Beep, Beep, Beep,Beep” audio response.)NOTE ODOUR REMOVING • Timer setting of ODOUR CLEAR OPERATIONS:Operating conditions: Outdoor temperature: 35°C and below,Indoor temperature : 35°C and below When the “Timer setting of ODOUR CLEAR OPERATION” mode is active, it is not possible to cancel the operation. The odour clear mode of all rooms are carried out by setting the odour clear mode one room. It is normal to hear some “Pish... Batt” noises during operations. When the indoor temperature rises, there may be some permeation of odour from the unit, thus it is recommended that youlet fresh air in by opening up some windows. The fan speed • air flow directions are automatically adjusted and are not directly controlled by the remote control. There aretimes when the vertical louvres are closed. (Not possible to adjust them) After this operation ends, the unit will return to the original operating modes: AUTOMATIC • HEATING • COOLING • DRY •AIR CIRCULATION modes.( )Odour wash mode lamp(Green) blinksReturns to originalcondition after 50 minutes