Panasonic CX-400 Series Instructions Manual

Also see for CX-400 Series: User manual Instruction manual Manual Instruction manual User manual

Contents

2Connector cables for the M12 pigtailed typeConnector cables for the M8 connector type Two sets of cables are required for the thru-beam type sensor.The following symbols are used in this section.Pin assignment Only the thru-beam receiver incorporates the output.NPN output type Only the thru-beam receiver incorporates the output.PNP output type Only the thru-beam receiver incorporates the output.Mount the sensor with a tightening torque of 0.5N·m or less.Thru-beam type sensor1. Set the operation mode switch to the Light-ON mode position (L side).2. Placing the emitter and the receiver face to face along a straight line.Move the emitter up, down, left and right to determine where light isreceived with the help of the receiver’s operation indicator (orange). Setthe emitter in the middle of this area.3. Adjust the angle of the emitter by twisting it up, down, left and right.4. In a similar manner, adjust the angle of the receiver.5. Check that the stability indicator (green) lights up.6. Choose the desired operation mode, Light-ON or Dark-ON, with theoperation mode switch.3 CONNECTOR CABLESType Model no. Cable length2-core typeCN-22-C2 2mCN-22-C5 5m4-core typeCN-24-C2 2mCN-24-C5 5mType Model no. Cable lengthStraight typeCN-24A-C2 2mCN-24A-C5 5mElbow typeCN-24AL-C2 2mCN-24AL-C5 5m4 I/O CIRCUIT DIAGRAMSSymbol MeaningD Reverse supply polarity protection diodeZD Surge absorption zener diodeTr NPN / PNP output transistorM12 pigtailed type Terminal name M8 connector type1) +V2) Not connected3) 0V4) Output (see note)123 4 1234DTrZDZD+- ±10%100mA max.Color code of cable with connector(Brown / 1) +V(Blue / 3) 0V(Black / 4)Output (note)LoadInternal circuit Users' circuit12 to 24V DCSensor circuit5 MOUNTING AND ADJUSTINGDTrZD +- ±10%ZD100mA max.(Brown / 1) +V(Blue / 3) 0V(Black / 4)Output (note) Load12 to 24V DCInternal circuit Users' circuitColor code of cable with connectorSensor circuitSensor mountingbracket (optional)12mm M3 screwswith washersEmitterReceiverObject to be sensedRamco Nationalwww.PanasonicSensors.com1-800-280-6933