Panasonic DLP PT-D3500U Operating Instructions Manual

Also see for PT-D3500 - XGA DLP Projector: Setup and operation manual Specifications Spec file

Contents

Panasonic DLP PT-D3500U Operating Instructions Manual Manual pdf 22 page image

22ProjectionPowering up the projectorRemove the lens cover.Connect the supplied power cable.(120 V AC, 50 Hz/60 Hz)Press the “I” marked side of the MAINPOWER switch to turn on the power.The power indicator lights up red, and the projector isplaced in the standby mode.Press the POWER button on the mainunit, or the POWER ON (|) button on theremote control.The power indicator illuminates in green and soonthe image is projected on the screen.Making adjustment andselectionRoughly adjust the focus of the lens.(Refer to page 24.)Press the LENS button on the main unit or theremote control unit to display a focus adjustmentscreen. Pressing buttons to adjust theimage into focus.Select and set the projection scheme.(Refer to page 35.)Select the input signal by pressing theinput selector button (the RGB/VIDEObutton on the main unit, or theRGB1/RGB2/VIDEO/S-VIDEO/DVI buttonon the remote control).Turn the feet, and adjust the tilt of themain unit in the front and rear or leftand right.Use the lens left/right adjustment dial toadjust the direction of the lens. (page 24)Press the LENS button three times toadjust the lens shift. (Refer to page 24.)Press the AUTO SETUP button if theinput signal is RGB/DVI signal. [on themain unit or the remote control]Fit the image size to the screen size.Press the LENS button twice and adjust the zoomof the lens on the lens zoom adjustment menu.Press the LENS button and adjust thefocus of the lens on the lens focusadjustment menu.Display the zoom adjustment menuagain and adjust the zoom of the lens tofit the image size to the screen size.(Refer to page 24.)• If the projector is powered up at about0˚C, a warm-up period of approximatelyfive minutes may be necessary to startprojection.The temperature monitor (TEMP) lightsduring the warm-up period.When the warm-up is completed, thetemperature monitor (TEMP) turns off andthe image is projected on the screen.• If the surrounding temperature is very lowand the warm-up period exceeds fiveminutes, the control determines it as anabnormal condition and turns off thepower automatically. If this happens, raisethe surrounding temperature to 0°C orhigher and then turn the main power “on”and turn the power “on” (|).Note