Panasonic DMR-BWT450 Operating Instructions Manual

Contents

RecordingSQT0826 27Recording TV programmesRecordingTo set the recording time1 Select “Recording Time” or “Continuousrecording” in step 4 (> left).Recording Time:You can set the length of recording time from30 minutes to 4 hours.• You can select the recording time with[2, 1].Continuous recording:The recording is continued until you press[STOP ∫].2 Press [OK].To convert the recording mode after recordingin DR modeRefer to “File Conversion”. (> 45)To confirm whether the conversion iscompletedRefer to “To confirm whether the conversion iscompleted”. (> 45)To cancel a conversionRefer to “To cancel a “During standby”conversion”. (> 45)• If a timer recording reaches its start time when all tunersare being used for recording, the recording of one of theprogrammes terminates.• Teletext will not be recorded.• Following contents or media cannot be played back whilerecording.- 3D video- video file- photo- USB HDD (For data files, > 10) and USB memory• Copying cannot be performed while recording.• When “Automatic Standby after OTR” is set to “On” (> 78),this unit is turned to standby mode if this unit is notoperated for approximately 5 minutes after completing“Automatic Stop” or “Recording Time”.• The title before conversion (the title recorded in DR mode)will be deleted once the conversion is completed.• Conversion will take about the same time as the recordedduration.• When the HDD does not have enough remaining space,conversion will not start.• Conversion is stopped when this unit is turned on.Conversion will start from the beginning again once the unitis switched to standby mode.• When converted, audio content and subtitle will beconverted with the same settings as at the start ofrecording.• This operation only records to built-in HDD.• This unit can record two programmes beingbroadcasted at the same time.1 Select the channel to record.2 Press [REC MODE] and select theconversion mode, then press [OK].• This unit will record the programmes in DRmode once, and then automatically convertto the selected recording mode while thisunit is in standby.• Recording mode (> 9)• The conversion mode set here is used asan initial value for the next recording.3 Press [REC ¥].Recording will start.4 Select “Automatic Stop”, then press [OK].• One touch recording (OTR)Recording stops automatically when theprogramme ends.• You can also select “Recording Time” or“Continuous recording”. (> right)HGHXHEHLHMXPSPLPEPOff (DR)Conversion Mode SettingOKRETURNHDD Remain: (DR)mhHighDefinitionData SizeLargeSmallLargeSmallStandardDefinitionAutomatic Stop at 8:45 AMREC1/OTRRecording TimeContinuous recording30 min8:00 AM - 8:45 AM