7RQT7458Getting started≥When there is no 21-pin Scart terminal on the television (➡page 8)≥Change the “AV2 Input” setting to match the output from a satellite receiver and set the “AV2 Connection” setting to “Normal” in the SETUPmenu (➡ page 43) after tuning is completed (➡page 11, 12).∫ To view satellite programmesPress [INPUT SELECT] to select the input channel “A2” for the satellite receiver or put this unit in standby mode.∫ RGBThis refers to the three primary colours of light, red (R), green (G), and blue (B) and also the method of producing video that uses them. Bydividing the video signal into the three colours for transmission, noise is reduced for even higher quality images.Connecting a television with 21-pin Scart terminal and Satellite receiverR - AUDIO - L VIDEOP RS-VIDEOR - AUDIO - L VIDEO S-VIDEOOPTICALOUT AV4 INRF INRF OUTDIGITAL AUDIO OUT(PCM/BITSTREAM)COMPONENTVIDEO OUT(PROGRESSIVE/INTERLACE)PBYAV1 (TV)AV2 (DECODER/EXT)AC INAV IN VHF/UHFRF INDVD/VCR2311 44To theaerialAerialleadCooling fanRF coaxial leadAC mains leadConnect only after all otherconnections are complete.To household mains socket(AC 220–240 V, 50 Hz)Fully wired 21-pinScart leadFully wired 21-pinScart leadAV1 terminalIf your television is equipped with RGB inputcapability, by connecting with a fully wired 21-pinScart lead you can see video using RGB output onthis unit (➡ below).To output in RGB select “RGB (without component)”from “AV1 Output” in the SETUP menu (➡page 43).Television’srear panelSatellite receiver’s rear panelThis unit’s rear panelindicates included accessories.indicates accessories not included.are required connections. Connect in the numbered order.BE SURE TO READ THE CAUTION FOR THE AC MAINSLEAD ON PAGE 2 BEFORE CONNECTION.