Panasonic DMR-EA38VK Operating Instructions Manual

Contents

Panasonic DMR-EA38VK Operating Instructions Manual Manual pdf 72 page image

72RQT9058Error MessagesOn the Unit’s Display PageH , F(“ ” stands for a service number.) An error has occurred. The number following “H” or “F” depends on thestatus of the unit. Check the items below and in the Troubleshooting Guide.If the service number still does not disappear after the check, reset the unit(¼ 74, “To restore the unit if it freezes”).− If the service numbers fail to clear, note the service numbers and contact aqualified service person.−RC (“ ” stands for a number.)  The remote control and the main unit are using different codes. Change thecode on the remote control.53HARD ERR(“HArd” and “Err” are alternatelydisplayed.) If there is no change after turning the unit on and off, consult the dealerwhere the unit was purchased.−NO READ(“NO” and “REAd” are alternatelydisplayed.) The disc is dirty or badly scratched. The unit cannot record, play, or edit. 67 The disc may be incompatible or of poor quality. 66, 67,69 You have used a lens cleaner and it has finished operation. Press[ OPEN/CLOSE] on the main unit to eject the disc.13 Displayed when the unit is started. This is not a malfunction. − The unit is carrying out its recovery process. You cannot operate the unitwhile “ ” is displayed.−FULL  There are already 16 scheduled recording programs. Delete unnecessaryscheduled recording programs.25UNSUPPORT(“UNSUP” and “POrt” are alternatelydisplayed.) You have inserted a disc the unit cannot play or record on. You tried to operate with a non-compatible USB memory.66, 6768UNFORMAT(“UNFOr” and “MAt” are alternatelydisplayed.) You have inserted a new DVD-RW/+RW or a DVD-RAM/DVD-RW(DVD-Video format) recorded on other equipment.You can format the disc when the format confirmation screen is displayed.23, 48“ ” is displayed on the unit’sdisplay. This unit is confirming that it is connected with equipment compatible withHDAVI Control.−F74  The HDMI connection could not be authenticated due to a transfermalfunction. Consult the dealer where the unit was purchased.−F75  The HDMI connection could not be authenticated due to an internal datamalfunction. Consult the dealer where the unit was purchased.−U59  The unit is very warm.The unit switches to standby for safety reasons. Wait for about 30 minutesuntil the message disappears.Reinstall the unit in an area with adequate ventilation. Do not block thecooling fan on the rear of the unit.−U61  There was a power failure or the AC power supply cord was disconnectedwhile the unit was on. The unit is carrying out its recovery process. Thisprocess restores the unit to normal operation. The unit is not broken. Waituntil the message disappears.−U72U73The HDMI connection acts unusually.– The connected equipment is not HDMI compatible.– Please use HIGH SPEED HDMI cables that have the HDMI logo (as shown on the cover).– The HDMI cable is damaged.−U76  HDMI cannot be output because you are connected to a model that doesnot support copyright protection.−U88  There was something unusual detected with the disc while recording,playing or copying; there was a power failure or the AC power supply cordwas disconnected while the unit was on. The unit is carrying out its recoveryprocess. This process restores the unit to normal operation. The unit is notbroken. Wait until the message disappears.76U99  The unit fails to operate properly. Press [/I POWER] on the main unit toswitch the unit to standby. Press [/I POWER] on the main unit again toturn the unit on.−