11RQT8307Getting started1 POWER button (POWER Í/I) (➡ 16)Press to switch the unit from on to standby mode or vice versa. Instandby mode, the unit is still consuming a small amount ofpower.2 Disc tray (➡ 20, 30)3 Connector for a digital video (DV) camcorder (➡ 47)4 Lights when the unit is turned on (if “Front Display” is set to“Bright” ➡ 56)5 SD card slot (➡ 5)6 Lights when the HDD, DVD or SD drive is selected7 Display (➡ below)8 Connectors for external equipment (➡ 47)9 Channel select (➡ 20): Open/close disc tray (➡ 20, 30); Select drive (➡ 20, 30, 34)Drive changes each time you press [DRIVE SELECT].< Stop (➡ 20, 30)= Start play (➡ 30)> Start recording/Remote control signal sensor (➡ 20)Specify the time to stop recording (➡ 21)Rear panel terminals (➡ 12)1 e.g.,[HDD]2 Channel3 Transferring (dubbing) indicator4 D.MIX (multi-channel DVD-Audio only)When lit: Down-mixing (➡ 68) is possible.When off:The disc prevents down-mixing so only the two frontchannels can be played (➡ 8, Regarding DVD-Audio).5 Recording mode6 Disc type7 Lights when the HDD, DVD or SD drive is selected8 Main display section9 Scheduled recording indicatorMain unitI N 2I N 2C HC HHDD DVD SDS VIDEOS VIDEO VIDEOVIDEO L/MONOL/MONO- AUDIOAUDIO - ROPEN/CLOSEOPEN/CLOSE D R ID R I V EV ES E L E C TS E L E C T R E CR E CPOWER/x1.3DVDV I NI N2 4 6 78 : ; < = >931 5Opening the front panelpart with your finger.Press down on theThe unit’s displayHDD REC PLAYPLAYRECXPSPLPEPDVDSDCH DUB D.MIX DVD AVCDRWRAMVRSD- +-1 2 3 5 647 8 9Recording Playback Recording/PlaybackHDD REC HDD PLAY HDD REC PLAY