5RQT8307Getting startedDisc and card handling∫ How to hold a disc or cardDo not touch the recordedsurface or the terminal surface.∫ Concerning non-cartridge discsBe careful about scratches and dirt.∫ If there is dirt or condensation on the discWipe with a damp cloth and then wipe dry.∫ Handling precautions≥Do not attach labels or stickers to discs. (This may cause discwarping and un-balanced rotation, rendering it unusable.)≥Write on the label side of the disc only with a soft, oil-based feltpen. Do not use ballpoint pens or other hard writing implements.≥Do not use record cleaning sprays, benzine, thinner, staticelectricity prevention liquids or any other solvent.≥Do not use scratch-proof protectors or covers.≥Do not expose the terminals of the card to water, garbage or otherstrange things.≥Do not drop, stack, or impact discs. Do not place objects on them.≥Do not use the following discs:–Discs with exposed adhesive from removed stickers or labels(rental discs, etc.).–Discs that are badly warped or cracked.–Irregularly shaped discs, such as heartshapes.≥Do not place in the following areas:–In direct sunlight.–In very dusty or humid areas.–Near a heater.–Locations susceptible to significant difference in temperature(condensation can occur).–Where static electricity or electromagnetic waves occur.≥To protect discs from scratches and dirt, return them to their casesor cartridges when you are not using them.The precision parts in this unit are readily affected by theenvironment, especially temperature, humidity, and dust.Cigarette smoke also can cause malfunction or breakdown.To clean this unit, wipe with a soft, dry cloth.≥Never use alcohol, paint thinner or benzine to clean this unit.≥Before using chemically treated cloth, carefully read theinstructions that came with the cloth.Observe the following points to ensure continued listening andviewing pleasure.Dust and dirt may adhere to the unit’s lens over time, making itimpossible to record or play discs.Use the DVD lens cleaner about once every year, depending onfrequency of use and the operating environment. Carefully read thelens cleaner’s instructions before use.[Note]Do not obstruct the rear panel’s internal cooling fan.Only insert or remove the SD card after turning the unit off.When the card indicator (“SD”) on the unit’s display is flashing, the card is being read from or written to. Do not turn off the unit or remove the card.Such action may result in malfunction or loss of the card’s contents.≥You can use SD Memory Cards with capacities from 8 MB to 1 GB (➡ 9).The manufacturer accepts no responsibility and offers no compensation for loss of recorded or edited material due to a problemwith the unit or recordable media, and accepts no responsibility and offers no compensation for any subsequent damage caused bysuch loss.Examples of causes of such losses are≥A disc recorded and edited with this unit is played in a DVD Recorder or computer disc drive manufactured by another company.≥A disc used as described above and then played again in this unit.≥A disc recorded and edited with a DVD Recorder or computer disc drive manufactured by another company is played in this unit.Unit careDVD lens cleaner: RP-CL720PPBefore moving the unit, ensure the disc tray is empty.Failure to do so will risk severely damaging the disc and theunit.Do not place the unit onamplifiers or equipmentthat may become hot.The heat can damage the unit.Inserting/Removing the SD cardOpening the cover Inserting the card Removing the card Closing the coverPress down.ADAPTERInsert the card label up with the cut-offcorner on the right.(Do not forget to close the cover. ➡ right)Press on the center ofthe card until it clicks intoplace.If you are using aminiSD TM card, insert itinto the miniSD TM cardadaptor that comeswith the card.Insert and remove thisadaptor from the unit.12Press on the centerof the card.Pull it straight out.Push up.Keep the small memory cards such as the SD Memory Card out of reach of children. If swallowed, seekmedical advice immediately.