RQT831436Changing the unit’s settings1 While stoppedPress [SETUP].2 Press [e,r] to select the tab andpress [q].3 Press [e,r] to select the menu andpress [ENTER].4 Press [e,r] to select the option andpress [ENTER].To return to the previous screenPress [RETURN].To exit the screenPress [SETUP].NoteThere may be differences in operation methods. If this happens,follow the on-screen instructions for the operation.The settings remain intact even if you switch the unit to standby.* 1 You can set these menus only after “Set Channels Automatically” is completed.* 2 You can set this menu only after “Set Clock Automatically” is completed.RETURNe,r,w,qENTERSETUPNumberedbuttonsCommon proceduresSetupChannelSetupDiscVideoA diPreset Channel CaptionsManual Channel CaptionsChannel CaptionsSignal Source (RF IN)Set Channels AutomaticallyCable TVTabs Menus OptionsSummary of settingsTabs Menus Options (Underlined items are the factory presets.)Channel Signal Source (RF IN) (Ô page 13) • Antenna • Cable TVSet Channels Automatically –Preset Channel Captions* 1 (Ô page 14) –Manual Channel Captions*1 (Ô page 14) –Setup Off TimerSelect how long the unit remains on when it is not being used.• 2 Hours • 6 Hours • OffRemote Control Code (Ô page 15) • Set Code 1 • Set Code 2 • Set Code 3Clock SettingsPress [ENTER] to show the following settings.Set Clock Automatically –Set Clock Manually (Ô page 15) –Adjust Time Zone* 2 (Ô page 15) • –1 • 0 • +1Quick StartIf you set Quick Start to on, you can start recording toDVD-RAM about 1 second after you press [^ DVD POWER] toturn the unit on and then sequentially press [* REC].• On • OffThe following happens when you have selected “On”.• Power consumption in standby mode increases because poweris supplied to the unit.Restore Default SettingsThis returns all values in the Setup menus, except for the clock,channel settings, ratings level, and on-screen language, to thedefault settings.• Yes • No