Panasonic DMR-ES20DEB Operating Instructions Manual

Also see for Diga DMR-ES20DEB: Operating instructions Quick start guide

Contents

Y PB PROPTICALCOMPONENTVIDEO OUT(PROGRESSIVE/INTERLACE) DIGITAL AUDIO OUT(PCM/BITSTREAM)S VIDEO OUTS VIDEOAV4 INAV4 IN OUTAUDIORRL LVIDEOAC INAV1 (TV)AV2 (EXT)RF OUT RF INAC INAC mains socketAC mains leadConnect DVD Recorder and TV set to the ACmains socket.231 Connect aerial to the RF IN (Aerial input)connector of the DVD Recorder.Connect the DVD Recorder´s RF OUT (Aerialoutput) to the TV set’s Aerial in connector.Disconnect the power of all units.Follow the steps for Auto-Setup on page 14.2AerialRF INAerial inputRF OUTAerial outputAC mains leadRF cable /Aerial cableerialAinputRF cable /Aerial cable33TV1DVD RecorderAC IN~Follow the steps below.Connecting with RF cable (Aerial cable)Auto-Setup with RF cable (Aerial cable) (Automatic tuning)! Turn on your television set.! With the Standby/on switch turn on the DVD Recorder. Automatic tuning for all availableTV stations begins. Approximate duration is 5 minutes.- While Auto-Setup is running the first digit of the DVD Recorder display will flash.After a while it will stop flashing and the RF output channel number will be displayed.- Select an unused channel pre-set on your TV and tune it to the RF output channelnumber shown on the DVD Recorder display (or until you can clearly see the Auto-Setupscreen). Store the new RF output channel (refer to the instructions for your TV).In some cases, the RF output channel may interfere with the TV stations transmitted inyour area. This may prevent you from seeing the On-Screen Display clearly.Please see page 15 for removing the interference before restarting Auto-Setup.You can complete the Owner ID now or skip this step and do it later. To do it later, press theRETURN button. Your DVD Recorder is now ready to use.! To set the Owner ID now, use and press the Numeric buttons or to enter a four-digit PIN number. Press , to correct the digit.! Make sure that you will remember the PIN number (make a note of it).! Press the ENTER button twice to confirm.! Enter the [Name], [House No] and [Postcode] in the same way, using .! Press the ENTER button to confirm each entry.! Press the RETURN button to leave the Owner ID screen.! You will now see the TV picture. Your DVD Recorder is now ready to use.Owner IDIf the clock setting menu appears(Auto clock set was not possible due to a weak signal)! Press to set the correct time and date and press ENTER to finish this setting.Note: A wrong date or time will influence the programmed recording of TV programmes(don't forget to change summer time and winter time).DVD DisplayClockOffAutomatic0 00 00 1 1 2005: : . .Time DateCHANGEENTER RETURNClock cannot be set automatically.Please set the clock manually.ENTER: store RETURN: leaveSELECT0 9NoAuto-SetupCh 4Suche Sender, bitte warten.RETURN: abbrechen35Auto-Setup in progress, please wait.RETURN: to abortRETURNOwner IDRETURNNameHouse No.PostcodePIN number * * * *RETURN : leave! After Automatic tuning has finished, the Owner ID screen will appear.1443Downloaded From Disc-Player.com Panasonic Manuals