Panasonic DMR-EX75 Operating Instructions Manual

Also see for DMR-EX75: Operating instructions Operating instructions Setup guide

Contents

FUNCTIONSFUNCTIONS65SETUPSetupSetup TV AspectProgressiveTV System16:9OffPALAV1 Output ( Scart ) VideoAV2 SettingsSetupAV2 Input RGB / VideoAV2 SettingsExt Link Ext Link 2RGB / VideoAV2 InputRGBVideoS VideoHDMI SettingsTABSELECTRETURNENTERConnection Setting ENTERENTER OptionTV Aspect [16:9] [4:3] [Letterbox]Progressive [On] [Off]On: The signal is displayed in full-picture quality using COMPONENT VIDEO OUT.Cannot be changed over when HDMI [Digital Audio Output] is set to [Automatic] andthe HDMI terminal is being used.TV SystemAV1 Output ( Scart )AV2 SettingsAV2 Input[PAL] [NTSC][RGB / Video] [RGB] [Video] [S Video]AV2 InputExt LinkExt Link [Ext Link1] [Ext Link 2]HDMI SettingsVideo ( with Component ): Factory-default settings.S Video ( with Component ): Select when a TV is connected that can receive anS Video signal.RGB 1 ( without Component ): RGB output is available all the time while this unitis on.RGB 2 ( without Component ): RGB output is available only during playback or on-screen display.[Video ( with Component )][S Video ( with Component )][RGB Component )][RGB 2 ( without Component )]1 ( without9966ENTER RETURNSELECT9919To OthersTuningDiscPictureSoundDisplayConnectionOthersTuningDiscPictureSoundDisplayConnectionOthersSelect the TV screen format of your television. Programmes in 16:9 format are recordedin 4:3 format. 16:9 format is used to record to HDD/RAM.Letterbox: Black bars appear on the upper and lower edges of the screen (16:9).PAL: You connect the unit to a PAL or multi-system television. Programmes that wererecorded with NTSC are played as PAL60.NTSC: You connect the unit to an NTSC television. Programmes that were recordedwith NTSC are played as NTSC.HDMI (High Definition Multimedia Interface) is a digital interface for Audio and Video.One single cable transfers both digital video data (pictures) and also digital audio data.There is no longer any need to convert analogue-digital or digital-analogue.HDMI works without data compression so that there is therefore no quality loss fromthe system.Perform the settings in thefollowing submenus for theconnected unit.RGB / Video: When receiving or recording RGB output from external equipment.RGB, Video, S Video: The input is switched to the selected signal.Ext Link 1: For digital receivers that send a special recording control signal,for example, the F.U.N. receiver (TU-DSF41).Ext Link 2: External recording control for satellite or digital receivers (video signal).AV-Link functionSwitching between television reception andthe signal from the DVD Recorder. Thisfunction is only possible if the AV1 Outputis set to [Video ( with component )] or[RGB 2 ( without component )].DVD recorder signal: Press ENTER + 0.DVD appears on the display.Television reception: Press the buttons again.TV appears on the display.Active Antenna OffActive AntennaOn: When you connect an aerial which shares the power circuit of the DVD Recorder.Start the Auto Setup again after making the adjustment and check theSignal Condition.[On] [Off]9960Not NTSC:RGB / Video, S VIDEO, Ext Link 1, Ext Link 2.