28Preparation:Turn on the unit and connected equipment.[RAM] If the disc is protected, release protection(¼ 52).[VHS] Ensure accidental erasure tab is intact.When recording multilingual broadcasts (¼ 23)DRIVESELECT to select the drive (DVD orVHS).Insert a disc or VHS cassette.REC MODEto select the recordingmode (¼ 24).INPUT SELECTIN1TVIN2DVOKInput Select2341Recording from an External DeviceRecording from a VCR, etc.Connect cables while the power to both the unit and theexternal device is off.Front of the unitS VIDEOIN 2 VIDEO /MONO AUDIO RLYou can get asharper, clearerpicture by connectingwith an S Video cableinstead of the yellowvideo cable. Yellow White RedS Video cable Audio/videocable[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW]Perform steps 1−5 left.Start play on an external device.RECto start recording theprogram from an external device.PAUSEto start recording theprogram from the external device.Perform steps 1−5 left.PLAYto locate the point on thetape where you want to insert therecording.PAUSEwhen you reach that point.RECto put the unit in recordingstandby.Start play on the external device.Recording to VHSRecording to DVDTipsIf the external equipment only has a single audio output,connect it to the L/MONO (white) IN2 terminal.TipsTo skip unwanted partsPress [ PAUSE] to pause recording. (Press again to restartrecording.)To stop recordingPress [ STOP]., to select “IN1” or “IN2”,then OK– Rear Panel inputs are IN1.–Front Panel inputs are IN2.NotesIf video is copied from another piece of equipment to this unit, thenthe video quality will be degraded.You can also connect to the IN1 on the rear.Downloaded From Disc-Player.com Panasonic Manuals
