![Panasonic DMR-EZ49VEB Operating Instructions Manual Manual pdf 7 page image](https://manuals-archive2.s3.amazonaws.com/5430387/2e7abbcaea0805751c1f5496bbf1e38b7f.jpg)
VQT2J517Media HandlingHolding a discHandle discs by the edges to avoid inadvertently scratching orgetting oil from your fingers on the disc. Do not touch the signalsurface of discs (the shiny side).Cleaning discsDiscs are not indestructible and occasionally dirt orcondensation may appear. Clean by gently wiping with a soft,dry lint-free cloth in a straight line from the centre of the disc tothe edge of the disc.Return discs to their cases when not in use; this helps to protectagainst scratches and dirt.Storing discs≥ Do not place or store discs in the following locations:– Direct sunlight– Very dusty or humid areas– Near a heat source– Places that undergo extreme shifts in temperature(condensation can occur)– Where static electricity or electromagnetic waves occurDiscs to avoid≥ Discs that are not perfectly circular in shape≥ Warped discs, which may not balance properly in your unit,causing improper operation or damage to the unit≥ Cracked discs≥ Discs with exposed adhesive (from removed stickers orlabels, such as may occur with rental discs or improperlycared-for discs that were previously labelled or re-labelled)1 Press [< OPEN/CLOSE] to open the tray.– Insert a disc.2 Press [< OPEN/CLOSE] to close tray.Automatic drive select function[DVD-V] [VCD] [CD]≥ If the unit is stopped, it automatically switches to the DVDdrive when a disc is inserted.Inserting the USB memory≥ Before inserting any USB memory to this unit, ensure that thedata stored therein has been backed up.≥ Check the orientation of the USB connector and insert itstraight in.≥ Insert an USB device while the unit is stopped, so the “USBdevice” screen is displayed. Select an item, then press [OK]to switch to the USB-related operations (> 42, 60).Removing the USB memory≥ Complete all USB-related operations and pull the USBmemory straight out.≥ If a USB memory being accessed is pulled out, then the datamay be damaged.Insert a video cassette.(The surface on which you can see a roll of tape shouldface up.)The unit is automatically turned on.To eject:From the main unit≥ Press [< EJECT] on the main unit.From the remote control≥ Press [DRIVE SELECT] to select VHS drive and then pressand hold [∫] for about 3 or more seconds.Video cassettes≥ Break off the video cassette’s tab toprevent accidental erasure.Cover the hole with a double layer ofadhesive tape when you want to use thevideo cassette for recording again.≥ You can use video cassettes with theVHS and S-VHS marks, but the unit isunable to make full use of thecharacteristics of S-VHS videocassettes.Video cassette care≥ Poor quality or damaged video cassettes can cause theheads to become dirty and malfunction. Store your videocassettes carefully and discard them when they become dirtyor damaged.≥ Never use video cassettes on which juice has been spilled orthose that are extremely damaged since this will not onlycause the heads to become dirty, but will also make the unitmalfunction.Disc CareInserting DiscsNotes≥ Ensure the disc is flat in the tray.≥ When using DVD-RAM or DVD-R, remove the disc from thecartridge. Cartridge discs cannot be used.≥ It is not possible to record or play continuously from oneside of a double sided disc to the other. You will need toeject the disc and turn it over.Insert label-up.Inserting/Removing the USB memoryInserting a video cassetteVideo Cassette InformationTab