273DP-1510P/1810P/1810F/2010EAPR 2002Edition 2.05.2.2. Service Mode 1 (Function Parameter Setting)Use the following procedure to change the function parameters.Note:The following buttons provide these functions in the Service Mode:Service Mode 1 : For DP-1810FStep Operation or Unit Condition LCD Display1 Standby2 Press “FUNCTION” and then “7”.3 Press “MONITOR” four times, then press “*”.4 Press “1”.5 Enter the Function Parameter Number or press “V” or“/\ “ to select the desired parameter.Ex: Changing the "ALARM STATUS" -- Enter "001"and press [SET].6 Press “START”.7 Enter the new setting value. Ex: Enter "3" for Constant.8 Press “START”. The new value will be stored and thenext parameter will be displayed.9 Repeat steps 4 through 7 to change other FunctionParameters or Press “STOP” twice to return tostandby."START": : The new setting value is stored in the machine."V” : Scroll the function parameter number down."/\ “ : Scroll the function parameter number up.MMM-dd-yyyy 15:0000%SET MODE (1-4)ENTER NO. OR VSERVICE MODEENTER NO. OR VPARAMETER (000-299)ENTER PARAMETER #_PARAMETER #001ALARM STATUS?ALARM STATUS:Timer1:OFF 2:Tmr 3:CONSTALARM STATUS:Const.1:OFF 2:Tmr 3:CONSTPARAMETER #002STOP COMM.JRNL?MMM-dd-yyyy 15:0000%
