Panasonic DP-1510P Service Manual

Also see for DP-1510P: Operating instructions Operating instructions Operating instructions Technical guide

Contents

93DP-1510P/1810P/1810F/2010EAPR 2002Edition 2.03.4.2. Updating the Host Firmware using the Master Firmware CardA. When a 4 MB Flash Memory Card was used1. Before starting, print the F5 & F6 Parameters (Copier) Lists.2. Turn the Power Switch to the OFF (O) position.3. Install the appropriate Master Firmware Card into the machine.4. Turn the Power Switch to the ON (I) position.5. Press “FUNCTION”, “ORIGINAL SIZE” keys and then Key “3” on the keypad sequentially.6. Perform the Copy Service Mode F9-07-00 (FIRMWARE UPDATE HOST PROGRAM <4MB>).7. The firmware is copied into the machine.8. After the update is completed, the machine reboots itself and returns to standby.9. Perform the Copy Service Mode F9-06-00 (PARAMETER INITIALIZE).10. Turn the Power Switch to the OFF (O) position.11. Remove the Master Firmware Card from the machine.12. Turn the Power Switch to the ON (I) position.13. Reprogram the F5 & F6 Parameters (Copier) according to the lists printed in Step 1 above if thesettings are other than factory default.B. When two 2 MB Flash Memory Cards were used1. Before starting, print the F5 & F6 Parameters (Copier) Lists.2. Turn the Power Switch to the OFF (O) position.3. Install the Master Firmware Card (Part A) into the machine.4. Turn the Power Switch to the ON (I) position.5. Press “FUNCTION”, “ORIGINAL SIZE” keys and then Key “3” on the keypad sequentially.6. Perform the Copy Service Mode F9-07-01 (FIRMWARE UPDATE HOST PART A <2MB>).7. The firmware is copied into the machine.8. After the update is completed, the machine reboots itself and returns to standby.9. Turn the Power Switch to the OFF (O) position.10. Remove the Master Firmware Card (Part A) and install the Master Firmware Card (Part B) into themachine.11. Turn the Power Switch to the ON (I) position.12. Press “FUNCTION”, “ORIGINAL SIZE” keys and then Key “3” on the keypad sequentially.13. Perform the Copy Service Mode F9-07-02 (FIRMWARE UPDATE HOST PART B <2MB>).14. The firmware is copied into the machine.15. After the update is completed, press "STOP" first and then press “FUNCTION” + “CLEAR” keyssimultaneously to return to standby.16. Turn the Power Switch to the OFF (O) position.17. Remove the Master Firmware Card from the machine.18. Turn the Power Switch to the ON (I) position.19. Perform the Copy Service Mode F9-06-00 (PARAMETER INITIALIZE).20. Reprogram the F5 & F6 Parameters (Copier) according to the lists printed in Step 1 above if thesettings are other than factory default.