Panasonic ET-MDNFB10 Operating Instructions Manual

Contents

Panasonic ET-MDNFB10 Operating Instructions Manual Manual pdf 13 page image

Menu navigationENGLISH - 13Notef The backup function is enabled when [BACKUP INPUT MODE] is set to anything other than [OFF] and same signal is input to the primaryinput and the secondary input.f To switch to the backup input signal using the backup function, make sure that the following three conditions are satisfied to be ready to usethe function.g Set [BACKUP INPUT MODE] to anything other than [OFF].g Input the same signal to the primary and secondary inputs.g Display the image of the primary input or secondary input.f If the input is switched to other than the primary or secondary input while the backup function is ready for use, the state of readiness touse the backup function is canceled. To switch to the backup input signal using the backup function again, switch to the primary input orsecondary input.f When [BACKUP INPUT MODE] is set to anything other than [OFF], the combination of that input is displayed in [PRIMARY INPUT] and[SECONDARY INPUT] of the [BACKUP INPUT SETTING] screen.f When [BACKUP INPUT MODE] is set to anything other than [OFF], [BACKUP INPUT STATUS] is displayed in the input guide and the[STATUS] screen.When the signal can be switched to the backup input signal using the backup function, [ACTIVE] is displayed in [BACKUP INPUT STATUS].When it is not possible, [INACTIVE] is displayed instead.The secondary input will be the backup input when [BACKUP INPUT STATUS] is displaying [ACTIVE] while the image from the primaryinput is displayed.The primary input will be the backup input when [BACKUP INPUT STATUS] is displaying [ACTIVE] while the image from the secondaryinput is displayed.f When [BACKUP INPUT MODE] is set to anything other than [OFF], the input is switched seamlessly if the input is switched between theprimary input and the secondary input while it is possible to switch to the backup input signal.f When [AUTOMATIC SWITCHING] is set to [ENABLE], and [BACKUP INPUT STATUS] shows [ACTIVE], the signal is switched to thebackup input if a disruption occurs in the input signal.f When [AUTOMATIC SWITCHING] is set to [ENABLE], the indication in [BACKUP INPUT STATUS] will change to [INACTIVE] if the inputsignal is disrupted and automatically switched to the backup input. In this case, it is not possible to switch to the backup input signal until theoriginal input signal is restored. If the input has switched to the backup input automatically, it is possible to switch to the backup input signalwhen the original signal has restored. In this case, the current input is maintained.f The primary input setting values are applied to image adjustment values such as the [PICTURE] menu → [PICTURE MODE], [GAMMA],and [COLOR TEMPERATURE].[SLOT IN]Set this item according to the input signal when this Interface Board is installed in the slot.Setting [RESOLUTION] in [SLOT IN] (OPT input)1) Select [DISPLAY OPTION] from the main menu.2) Press the button.f The [DISPLAY OPTION] screen is displayed.3) Press as to select [SLOT IN].4) Press the button.f The [SLOT IN] screen is displayed.5) Press as to select [SDI OPT1] or [SDI OPT2], and press the button.f The detailed setting screen for the selected item is displayed.6) Press as to select [RESOLUTION], and press the button.f The [RESOLUTION] screen is displayed.7) Press as to select an item, and press the button.f Select [AUTO], [1280x720p], [1920x1080i], [1920x1080p], [1920x1080sF], [2048x1080p], [3840x2160p], or[4096x2160p].Setting [SDI MAPPING] in [SLOT IN] (OPT input)1) Select [DISPLAY OPTION] from the main menu.2) Press the button.f The [DISPLAY OPTION] screen is displayed.3) Press as to select [SLOT IN].