Panasonic ET-MDNFB10 Operating Instructions Manual

Contents

Panasonic ET-MDNFB10 Operating Instructions Manual Manual pdf 21 page image

AppendixENGLISH - 21AppendixTroubleshootingReview the following points.Problems Points to be checkedThe OPT input image is notdisplayed.f Is the SFP module installed correctly?f Is the optical fiber cable connected correctly?f Is a signal not supported by this Interface Board or the SFP module input?f Is there dust or dirt on the connector of the SFP module or the optical fiber cable?Cannot switch to the inputof the Interface Board. f Is the Interface Board correctly installed in the slot?Attentionf If problems persist even after checking the preceding points, consult your dealer.Control commandThe following table describes a command to switch to the input of this Interface Board installed on the projectorfrom a computer.Command Details Parameter RemarkIIS Switching the inputsignalAU1,OP1*1 SDI OPT1 [SLOT1], SDI OPT1 [SLOT]AU1,OP2 *1 SDI OPT2 [SLOT1], SDI OPT2 [SLOT]AU2,OP1 *2 SDI OPT1 [SLOT2]AU2,OP2 *2 SDI OPT2 [SLOT2]*1 This can be used when this Interface Board is installed in 1> or .*2 This can be used when this Interface Board is installed in 2>.