Panasonic ET-MDNFB10 Operating Instructions Manual

Contents

Panasonic ET-MDNFB10 Operating Instructions Manual Manual pdf 8 page image

Installing the SFP module8 - ENGLISHInstalling the SFP moduleThis section explains an example of a procedure to install and remove the SFP module. Please also check theoperating instructions and setup guide of the SFP module to be installed.How to install the SFP moduleSFP portsCircuit boardsSFP modulesFig. 11) Remove the port cover.f Pull out the port cover of the SFP port.2) Install the SFP module to the SFP port. (Fig. 1)f With the circuit board of the SFP module visible from the top, securely insert the SFP module all the way.f Remove the protection cap on the terminal, terminal, or OUT> terminal, if there is any, before using.Attentionf The removed port cover and the protection cap will be needed in following cases. Store them so that they can be attached in the future.g When the SFP module not required anymore is removedg When there is a terminal not to be usedg When storing the SFP moduleHow to remove the SFP moduleFig. 2Fig. 1SFP modulesLeverLeverLatch1) Disconnect the optical fiber cable.f If the optical fiber cable is connected to the SFP module, remove the cable while releasing the latch of theoptical fiber cable.2) Release the latch of the SFP module. (Fig. 1)f Pull up the lever on the SFP module to release the latch.