- 18 -Access lamp [ACCESS] A≥ When this unit is accessing the SD card, the access lamp lights up.1 Open the SD card cover and insert (remove) the SD card into (from) the cardslot B.≥ Face the label side C in the direction shown in the illustration and press it straight in as far as itwill go.≥ Press the center of the SD card and then pull it straight out.2 Securely close the SD card cover.≥ Securely close it until it clicks.≥ Do not touch the terminals on the back of the SD card.≥ Do not apply strong shocks, bend, or drop the SD card.≥ Electrical noise, static electricity or the failure of this unit or the SD card may damage or erase thedata stored on the SD card.≥ When the card access lamp is lit, do not:j Remove the SD cardj Turn the unit offj Insert and remove the USB cablej Expose the unit to vibrations or shockPerforming the above while the lamp is on may result in damage to data/SD card or this unit.≥ Do not expose the terminals of the SD card to water, dirt or dust.≥ Do not place SD cards in the following areas:j In direct sunlightj In very dusty or humid areasj Near a heaterj Locations susceptible to significant difference in temperature (condensation can occur.)j Where static electricity or electromagnetic waves occur≥ To protect SD cards, return them to their cases when you are not using them.≥ About disposing of or giving away the SD card. (l 248)VX981
