- 87 -≥ Using a tripod is recommended.≥ In darker areas, Auto Focus may focus a bit slower. This is normal.≥ Night Mode is not available when [REC FORMAT] is set to [24p] and [WIDE CONV. LENS SET] isset to [ON].Night Mode ([COLOR])≥ Recorded scene is seen as if frames were missed.≥ If set in a bright place, the screen may become washed out for a while.≥ Bright dots that are usually invisible may be seen, but this is not a malfunction.Night Mode ([Infrared])≥ Do not use ([Infrared]) in a bright location. Doing so may cause a malfunction.≥ When ([Infrared]) is set, observe the following points:j Do not cover the infrared light with your hand or other object.j When a Conversion Lens (optional) is attached to this unit, do not use the setting.≥ The maximum distance that the infrared light can reach is approximately 3 m (9.8 feet).≥ You can record a clear image by positioning the center area of the screen over the subject.You can change the level of image contrast correction in HDR Movie Mode. (l 50, 65)The icon changes each time you touch it.(Low) # (High)≥ You cannot change the level of this effect when recording a motion picture or during PRE-REC.≥ You may not see the full effect depending on the recording conditions.This function detects the horizontal tilt of the unit, and automatically corrects it to the levelposition.Each touch of this icon switches Level Shot Function.(Normal) # (Strong) # Off≥ The icon changes when the tilt exceeds the correction range.≥ When the tilt exceeds the correction range, move the unit to the position where / isdisplayed.HDR Effect(Low): Sets the correction level to low.(High): Sets the correction level to high.Level Shot Function(Normal): Corrects the tilt.(Strong): Strengthen tilt correction.Off: Cancel the setting./ When the tilt is corrected/ / / When the tilt is above the correction range
