- 258 -3 Press the recording start/stop button.(When [Party Scene]/[Moving Object] is selected)≥ Before recording starts, the Remote Pan Tilt Cradle rotates and returns to its home position. Ittakes time until recording starts.≥ The Remote Pan Tilt Cradle operates within the range set in advance.(When [Manual]/[Preset Positions] is selected)≥ Performing the operation of Step 2 during recording may cause the recording screen to shake orthe Remote Pan Tilt Cradle to move from its original location.To switch the Remote Pan Tilt Cradle ModeTouch .≥ The selection screen of the Remote Pan Tilt Cradle Mode is displayed. Touch the desired mode.To exit the Remote Pan Tilt CradleTouch [EXIT].≥ The Remote Pan Tilt Cradle rotates and returns to its home position.≥ After the operation, the Remote Pan Tilt Cradle turns off. Before removing this unit, disconnectthe USB cable.∫ Registering positions to the position buttons1 Touch .2 Touch the position button to which you want to register a position.≥ You can register positions to [POS1]/[POS2]/[POS3]/[POS4]/[POS5]≥ The position buttons without a registered position are indicated as [Not set].3 Determine a position with / / /≥ You can also operate the zoom with the zoom lever.4 Touch [ENTER].≥ To register positions to other position buttons, repeat Steps 2–4.≥ To adjust a position that has already been registered to a position button, touch the positionbutton to which the position you want to adjust is registered, and follow Steps 3–4.∫ Moving the Remote Pan Tilt Cradle to a registered position1 Touch .≥ Check that is highlighted in yellow.≥ The position buttons ([POS1]/[POS2]/[POS3]/[POS4]/[POS5]/[HOME]) will be displayed.These buttons will disappear when no touch operation is performed for approximately 5 seconds.To display them again, touch the screen.2 Touch the desired position button.≥ The Remote Pan Tilt Cradle will move to the registered position of the selected position button.≥ You cannot select position buttons without a registered position.≥ If you touch [CANCEL], the Remote Pan Tilt Cradle will stop in a midway position.≥ To return to the home position, touch [HOME].∫ Using Cycle ModeIn this mode, the Remote Pan Tilt Cradle cycles through positions registered to the position buttonsin the desired sequence.The default sequence is as follows: [HOME] # [POS1] # [POS2] # [POS3] # [POS4] # [POS5]Setting up [Preset Positions]P O SP O S
