- 129 -∫ It is not a malfunction in following casesOthersTroubleshootingA clicking sound is heardwhen the unit is shaken.≥ This is the sound of the lens moving and is not a defect.This sound will no longer be heard when the unit is turnedon and change the mode to .Object seems to bewarped.≥ Object seems to be warped slightly when the object movesacross the image very fast, but this is because the unit isusing MOS for the image sensor. This is not a malfunction.PowerProblem Check pointsThis unit cannot beturned on.This unit does not stayon long enough.Battery runs downquickly.≥ Charge the battery again to ensure it is sufficientlycharged. (l 11)≥ In cold places, the battery using time becomes shorter.≥ The battery has a limited life. If the operating time is stilltoo short even after the battery is fully charged, thebattery has worn out and needs to be replaced.This unit cannot beoperated though it isturned on.This unit does notoperate normally.≥ Remove the battery or AC adaptor, wait about 1 minuteand then reconnect the battery or AC adaptor. Thenabout 1 minute later, turn on the unit again. (Conductingthe above operation while the media is being accessedmay damage the data on the media.)≥ If normal operation is still not restored, detach the powerconnected, and consult the dealer who you purchasedthis unit from.“ERROR OCCURRED.PLEASE TURN UNITOFF, THEN TURN ONAGAIN.” is displayed.≥ The unit has automatically detected an error. Restart theunit by turning off and on.≥ The unit will be turned off in about 1 minute if the unit isnot turned off and on.≥ Repair is needed if it is repeatedly displayed even if it isrestarted. Detach the power connected, and consult thedealer who you purchased this unit from. Do not attemptto repair the unit by yourself.
