Settings and Printing NetworkNetworkMaintenance and Spec.Appendix90■ TCP/IPName Factory Default DescriptionUse TCP/IP Protocol ENABLE Enables or disables TCP/IP protocol.Use DHCP/BOOTP ENABLE Enables or disables DHCP/BOOTP. Whenenabled, KX-P7310 gets an IP Addressfrom the DHCP/BOOTP server whilebooting. To use this function DHCP/BOOTPserver must exist on the network.Use RARP ENABLE Enables or disables RARP. RARP is aprotocol which obtains IP Address fromRARP server. When using this function, aRARP server must exist on the samenetwork.IP Address 0.0.0.0 IP Address for the network in which the KX-P7310 is installed.Subnet Mask 0.0.0.0 Subnet mask for the network in which theKX-P7310 is installed.Default Gateway 0.0.0.0 IP Address of the default gateway throughwhich systems on other networks can bereached.WINS Server -Primary (Preferred)WINS Server0.0.0.0 Sets the WINS server (primary) address.The Computer Name of the NetBEUI/NetBIOS is used for NETBIOS name.WINS Server -Secondary(Alternate) WINSServer0.0.0.0 Sets the WINS server (secondary) address.The Computer Name of the NetBEUI/NetBIOS is used for NETBIOS.WINS Server -Scope IDNULL Sets Scope ID.Use IP Filtering DISABLE Enables or disables IP Filtering.Filter Mode ACCEPT Sets the mode of the IP Filtering: DENY orACCEPT.Filter1 / Filter2 /Filter3 / Filter40.0.0.0 Sets the range of IP addresses for IPFiltering.Use IPv6 Protocol DISABLE Enables or disables IPv6 protocol.Use FTP/LPDBannerDISABLE Prints a banner page when using LPRprinting.
