Panasonic KX-HNH100AZ Operating Instructions Manual

Stopping the alertWhen a sensor is triggered, the hub andhandset sound an alert. Use the followingprocedure to stop the alert.1 Press MnN or MeN.2 Enter the PIN (default: “0000”,page 42). a MOKNNote:R By pressing M N, you can disarm thealarm system and stop the alert. See“Arming and disarming the system”,page 41.Displaying sensor statusThe status of each sensor device is shown onthe handset.1 M N#8012 MbN: Select “All Locations” or thearea in which the desired sensor devicesbelong to. a MOKN3 MbN: Select the desired sensor.R Press M N to refresh the displayedinformation.4 MeNTalking notification featureThis feature allows you to get informationabout a triggered sensor without looking at thedisplay. When a sensor is triggered, thehandset can announce the location of thesensor detected, the sensor name, and thetype of detection. The announcement is heardbefore the alert sounds. The default setting is“On”.1 M N#8092 MbN: Select the desired setting. a MOKN3 MeNAlert volumeYou can adjust the alert volume heard duringAt Home mode and Away mode.– “Alert Volume”: The volume of the alertthat sounds when the system is notdisarmed within the entry delay time(page 41).– “Entry Alert Volume”: The volume ofthe alert that sounds during the entry delaytime (page 41).– “Exit Alert Volume”: The volume ofalert that sounds during exit delay time(page 41).n Changing alert volume1 For handset:M N#803 (At Home) orM N#804 (Away)For hub:M N#*803 (At Home) orM N#*804 (Away)2 MbN: Select the desired setting. a MOKN3 MeNn Changing entry alert volume1 For handset:M N#808 (At Home) orM N#807 (Away)For hub:M N#*808 (At Home) orM N#*807 (Away)2 MbN: Select the desired setting. a MOKN3 MeNn Changing exit alert volume1 For hub:M N#805 (Away)2 MbN: Select the desired setting. a MOKN3 MeNSetting/changing the disarm PINYou must enter the disarm PIN in order todisarm the alarm system or stop an alert. Thedefault PIN is “0000”. We recommendchanging the disarm PIN.Important:R When you change the disarm PIN, pleasemake note of the new PIN. The unit will notreveal the PIN to you. If you forget the PIN,contact an authorised service centre.1 M N#81042Home Network System Integration