Answering systemProblem Cause/solutionThe unit does not record newmessages.R The answering system is turned off. Turn it on (page 34).R The message memory is full. Erase unnecessarymessages (page 35).R The recording time is set to “Greeting Only”. Changethe setting (page 39).R Your phone service provider’s voice mail service may beanswering your calls before the unit’s answering systemcan answer your calls. Change the unit’s number of ringssetting (page 39) to a lower value, or contact your phoneservice provider.I cannot operate the answeringsystem remotely.R The remote access code is not set. Set the remoteaccess code (page 37).R You are entering the wrong remote access code. If youhave forgotten your remote access code, enter theremote access code setting to check your current code(page 37).R The answering system is turned off. Turn it on (page 38).The answering system must be activated (page 34) inorder to turn it on remotely.The unit does not emit thespecified number of rings.R If the first ring is turned off, the number of rings decreasesby 1 from the specified number of rings.Liquid damageProblem Cause/solutionLiquid or other form of moisturehas entered the handset/hub.R Disconnect the AC adaptor and telephone line cord fromthe hub. Remove the batteries from the handset andleave to dry for at least 3 days. After the handset/hub arecompletely dry, reconnect the AC adaptor and telephoneline cord. Insert the batteries and charge fully before use.If the unit does not work properly, contact an authorisedservice centre.Caution:R To avoid permanent damage, do not use a microwave oven to speed up the drying process.52Useful Information