4.6 Outside Line ProgrammingPulse Speed Selection403System Programming 4-97Description An outside line set for pulse or call blocking mode in program[402] “Dial Mode Selection” can have two pulse rates, 10 pps (low)and 20 pps (high). This program sets the pulse speed for eachoutside line set to pulse or call blocking mode.Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)• 10 pps / 20 ppsDefault All outside lines – 10 ppsProgramming 1. Enter 403.Display: 403 PULSE SPEED2. Press NEXT.Display: CO Line NO?→3. Enter an outside line number.To enter outside line number 1, you can also press NEXT.Display example: CO1:10pps4. Keep pressing SELECT until the desired selection isdisplayed.5. Press STORE.6. To program another outside line, press NEXT or PREV, orSELECT and the desired outside line number.7. Repeat steps 4 through 6.8. Press END.Conditions • To assign all outside lines to one selection, press the key in step 3.In this case, the display shows the contents programmed for outside line1.• The pulse speed required is determined by the outside or PBX line.• Program [990] “System Additional Information, Field (17) and Field(21)” are used to select a pulse break ratio and inter-digit pause, ifneeded.Feature References Section 3, FeaturesDial Type Selection
