3-4 User Programming (Manager Programming)3.1 User Programming InstructionsBefore entering the programming modeBefore entering programming mode, confirm that:• Your telephone is on-hook, and• No calls are on hold at your telephone.Entering the programming modeTo enter the User Programming (Manager Programming) mode:Press PROGRAM + + + User Password (default:1234)• The display shows the Initial Message: USR-PGM NO?→Note:• If nothing is entered within five seconds after the PROGRAM button is pressed,programming is canceled.• During the programming mode, your extension is treated as a busy extension.• Only one proprietary telephone can be in programming mode at any one time.• The User Password is not shown on the display. The password can be changed bySystem Programming.Programming References• System Programming — Installation Manual[120] User PasswordIn this section, programs [000] through [004] are explained. Please consult with yourdealer when you need to change the following programs:• [005] Flexible CO Button Assignment• [006] Operator / Manager Extension Assignment• [008] Absent Messages• [009] Quick Dial Number Set