1.1 General FeaturesFeatures Guide 169Conditions• Toll Restriction check is done before LCR is applied.• LCR works according to the selected dialling plan. If the user-dialled number is not foundin the dialling plans, the dialled number is sent out with Local Access (Automatic lineaccess) Code.• This feature also applies to Call Forwarding – to CO Line.• The same code with different digits may be assigned in program [7X0Y] LCR LeadingDigit Entry for Plan 1-8 or in program [7X20] LCR Exceptional Code. In this case, the codewhich has smaller digits takes the more expensive route is priority. To prevent this, enter" " (wild card) after the code with the smaller digits. Examples are shown below:a) The code priority is as follows:"044" in program [7201] > "0444" in program [7101]In this case, "044 " should be assigned in program [7201].b) The code priority is as follows:"0332" in program [7120] > "03323" in program [7120]In this case, "0332 " should be assigned in program [7120].• When making a call to an ISDN line using the memory dialling, and the number has a pausein it, the number after the pause will be sent to the line as DTMF signals. This function isuseful when accessing a special network service which can be accessed only by the DTMFsignaling. Program [990], Area 07 – bit 1, is used to enable or disable this function (default:disabled).Programming Guide References• [100] Flexible Numbering• [103] Automatic Access CO Port Assignment• [311] Emergency Dial Number Set• [7000] LCR Mode• [7002] BTL Access Code• [7003] Itemised Code Set• [7004] ISDN Itemised Code Set• [7X0Y] LCR Leading Digit Entry for Plan 1-8• [7X1Y] LCR Time and Fee for Plan 1-8• [7X20] LCR Exceptional Code• [7X21] LCR Carrier Code• [7X22] LCR Carrier Modify Command• [7X23] LCR CO Port Assignment• [7X24] LCR Authorisation Code• [990] System Additional InformationFeatures Guide References• Line Access, Automatic
