2.5 Outside Line ProgrammingGeneral Programming 201[432] DID / TIE Outgoing AssignmentDescriptionAssigns a DID and TIE outgoing method, immediate or wink, to each DID / TIE formataccording to your central office service.Immediate: Outgoing DID and TIE numbers can be transmitted right after seizing the outsideline.Wink: Outgoing DID and TIE numbers can be transmitted after receiving the wink signal fromthe central office after seizing the outside line.Selection• DID / TIE format number: 1 through 8, ( =all DID / TIE formats)• Immediate / WinkDefaultAll DID / TIE formats – WinkProgramming1. Enter 432.Display: 432 SIGNAL OUT2. Press NEXT.Display: Format NO?3. Enter a DID / TIE format number.To enter DID / TIE format number 1, you can also press NEXT.Display example: 1:Wink4. Keep pressing SELECT until the desired selection is displayed.5. Press STORE.6. To programme another DID / TIE format, press NEXT or PREV, or SELECT and thedesired DID / TIE format number.7. Repeat steps 4 through 6.8. Press END.Conditions• The time the system waits for the confirmation wink signal can be programmed inprogramme [435] DID / TIE Wink Time Out Assignment.The system disconnects the outside line when the time-out time expires.• To assign all DID / TIE formats to one selection, press the key in step 3.In this case, the display shows the contents programmed for DID / TIE format number 1.
