4.12 Feature [6]Feature Guide 703ARS ModeSpecifies the ARS mode used when making a CO line call.DefaultSame as System SettingValue RangeOff: ARS is disabled.On for Local Access Operation: ARS operates when an extension user makes a call using any Idle LineAccess method.On for Any CO Access Operation: ARS operates when an extension user makes a call using any CO LineAccess method.Same as System Setting: The setting specified in ARS Mode in System Setting [8-1] is applied.Programming Guide References4.14.1 System Setting [8-1]Feature Guide References1.9.1 Automatic Route Selection (ARS)2.2.3 Tenant ServiceSystem Speed DialSpecifies which system speed dialing table is used by the tenant. This setting is only available when an MECcard is installed.DefaultSame as System SettingValue RangeSame as System Setting: PBX common system speed dialing numbers are used.Tenant Exclusive: Individual tenant system speed dialing numbers are used.Programming Guide References4.12.1 Speed Dialing & Caller ID—Main Table [6-1-1]Feature Guide References1.6.1.4 Speed Dialing—Personal/System4.12.9 Dialing Plan [6-7]The PBX sends all of the dialed digits at once after an extension user completes dialing. The PBX canrecognize the end of dialing when the dialed telephone number starts with the programmed leading numberand contains the programmed total number of digits.When the PBX recognizes the end of dialing to an analog CO line, the PBX cancels the muting of the caller'svoice sent to the analog CO line immediately. If the PBX cannot recognize the end of dialing, the PBX mutesthe caller's voice sent to the analog CO from the time at which the last digits is dialed until the analog CO
