Programmable Settings16Dialing ModeIf you have touch tone service, set to “Tone”. If rotary or pulse service isused, set to “Pulse”. Your phone comes from the factory set to “Tone”.Make sure the unit is not being used and the handset is lifted off thebase unit.1 Press (MUTE/FUNCTION).2 Scroll to “Initial set” by pressing Ö orÑ, and press á.3 Scroll to “Set tel line” by pressing Öor Ñ, and press á.4 Press á at “Set dial mode”.•The current setting is displayed.5 Select “Pulse” or “Tone” by pressing Ö orÑ.6 Press á (Save key).•A beep sounds.•To exit the programming mode, press (OFF).•You can exit the programming mode any time by pressing (OFF).--------------HSave directoryMessage playDate and timeHInitial set--------------Caller ID editHSet tel lineSet answering--------------HSet dial modeSet flash timeSet dial mode:ToneGF H=SaveSet dial mode:PulseFor Caller ID service users (p. 30)•The Caller ID information will reset the clock after the first ring if the adjustedtime is incorrect.•If the clock has not previously been set, the Caller ID information will not adjustthe clock.•The Caller ID information will automatically adjust the clock for daylight saving time.To check the date/time(MUTE/FUNCTION) \ Ö or Ñ to select “Date and time” \ á \\ Ö (Next key) TWICE \ Date and time will be displayed. \ (OFF)•When entering the time in step 6, you cannot enter numbers greater than 12. Donot use military time. (To set 13:00 hours, enter “0100”, and select “PM” bypressing (*).)