Panasonic KX-TG4711C Operating Instructions Manual

of the 5th ring when there are no newmessages. If you call your phone from outsideto listen to new messages (page 37), youknow that there are no new messages whenthe phone rings for the 3rd time. You can thenhang up without being charged for the call.1 MMENUN#2112 MbN: Select the desired setting. aMSAVEN a MOFFNFor Voice Mail service subscribersIf you subscribe to a flat-rate service packagethat includes Call Display, Call Waiting, VoiceMail, and unlimited local/regional/longdistance calls, please note the following:R To use the Voice Mail service provided byyour service provider/telephone companyrather than the unit’s answering system,turn off the answering system (page 35).R To use this unit’s answering system ratherthan the Voice Mail service provided byyour service provider/telephone company,please contact your service provider/telephone company to deactivate yourVoice Mail service.If your service provider/telephone companycannot do this:– Set this unit’s “Ring count” setting sothat this unit’s answering systemanswers calls before the Voice Mailservice of your service provider/telephone company does. It is necessaryto check the number of rings required toactivate the Voice Mail service providedby your service provider/telephonecompany before changing this setting.– Change the number of rings of the VoiceMail service so that the answeringsystem can answer the call first. To doso, contact your service provider/telephone company.Caller’s recording timeYou can change the maximum messagerecording time allowed for each caller. Thedefault setting is “3 min”.1 MMENUN#3052 MbN: Select the desired setting. aMSAVEN a MOFFNSelecting “Greeting only”You can select “Greeting only” which setsthe unit to announce a greeting message tocallers but not record messages.Select “Greeting only” in step 2 on“Caller’s recording time”, page 39.Note:R When you select “Greeting only”:– If you do not record your own message,the unit will play the pre-recordedgreeting-only message asking callers tocall again later.– If you use your own message, record thegreeting-only message asking callers tocall again later (page 36).Message alertYou can select whether or not the messageindicator on the handset flashes slowly whennew messages are recorded. The defaultsetting is “On”.Important:R If you stored the Voice Mail access number(page 40), the message indicator alsoflashes for newly recorded Voice Mailmessages (page 41).1 MMENUN#3402 MbN: Select the desired setting. aMSAVEN a MOFFNNote:R While message alert is on, batteryoperating time is shortened (page 11).39Answering SystemTG47xxC(en)_1212_ver021.pdf 39 2011/12/12 14:19:49