Panasonic KX-TG5471S Operating Instructions Manual

Contents

Panasonic KX-TG5471S Operating Instructions Manual Manual pdf 20 page image

Programmable Settings20Base unit ringer volumeMake sure the base unit is not being used.To set the ringer volume to high (preset), medium, or low, press [d] or [B].• To increase volume, press [B]. To decrease volume, press [d].• To stop ringing, press [STOP].To turn the ringer off, press and hold [d] until 2 beeps sound.• “ ” is displayed.To turn the ringer on, press [d] or [B].• The base unit will ring at the low level.• You can adjust the ringer volume while an outside call is ringing.Press [d] or [B] while the base unit is ringing.To turn the ringer off, press and hold [d] until 2 beeps sound. “ ” is displayed.Ringer ToneYou can set the handset and base unit ringers to use one of 7 ringer patterns foroutside calls. “Tone 1” to “Tone 3” are bell ringer patterns. “Melody 1” to “Melody 4”are preset melody patterns. The factory preset is “Tone 1”.• You cannot change the ringer tone for intercom calls.• If you subscribe to a Distinctive Ring Service (such as IDENTA-RING) from yourtelephone company with 2 or 3 consecutive rings, select a bell ringer pattern (Tone 1 to 3).If you select a melody pattern, you will not be able to distinguish lines by their ringers.• If you select one of the melody ringer patterns, the ringer will continue to sound forseveral seconds if:— the caller hangs up before you answer the call, or— another person answers the call using another phone connected on the same line.Handset ringer tone1 Press [MENU].2 Press the soft key ( ) at “Ringersetting”.3 Scroll to “Ringer tone” by pressing [d] or[B], then press the soft key ( ).4 Select the desired ringer tone by pressing[d] or [B].• The handset will ring and the ringer tone willchange. If the ringer volume has been turned off,the handset will not ring (p. 19).• You can also select the ringer tone by pressing[1] to [7].5 Press the soft key ( ), then press [OFF].Base UnitRINGEROFFRINGEROFFHandsetSELECTRinger settingSELECT Ringer toneRinger tone1:Tone 1SAVE