Programmable SettingsFor assistance, please visit http://www.panasonic.com/consumersupport 45Programming via direct commandsYou can also program features using “direct commands”—special codes that take youdirectly to the feature you wish to program and allow you to select the desired setting.There is no need to scroll through the unit’s menus.Details of each feature can be found on the corresponding pages.Important:L Before programming, make sure the handset and base unit are not being used. Thehandset must be operated near the base unit and while off the base unit or charger.1 Press {MENU} (middle soft key), then press {#}.2 Enter the desired feature code (shown below).3 Enter the desired setting code (shown below).L This step may vary depending on the feature being programmed.4 Press {SAVE}.5 Press {OFF} to exit programming mode.Note:L If the handset beeps 3 times, you entered an invalid code. Enter the correct code.L If you make a mistake or enter the wrong code, press {OFF} then start again bypressing {MENU}.Direct commands chartImportant:L The default settings are indicated by *.Feature Feature code Setting code PageDate and time {1} {0} {1} Enter date and time.(Default: 12.31.2005)20Change language {1} {1} {0} {1}: English* {2}: Spanish 53Set dial mode {1} {2} {0} {1}: Pulse {2}: Tone* 20Set flash time {1} {2} {1} {1}: 700 ms* {2}: 600 ms{3}: 400 ms {4}: 300 ms{5}: 250 ms {6}: 110 ms{7}: 100 ms {8}: 90 ms53Set line mode {1} {2} {2} {1}: A {2}: B* 54HS registration {1} {3} {0} Go to step 5 on page 56. 56Enter direct No.: