Answering System46Important:L In order to operate the answeringsystem remotely, you must first set aremote access code.1 1 (middle soft key) y3z62 To turn on remote operation, enterthe desired 3-digit remote accesscode.3 M s {ic}Deactivating remote operationPress * in step 2 on “Remote accesscode”, page 45.L The entered remote access code isdeleted.Using the answering systemremotely1 Dial your phone number from atouch-tone phone.2 After the greeting message starts,enter your remote access code.3 Follow the voice guidance promptsas necessary or control the unitusing remote commands (page 46).4 When finished, hang up.Voice guidanceDuring remote operation, the unit’s voiceguidance starts and prompts you topress 1 to perform a specific operation,or press 2 to listen to more availableoperations.Note:L If you do not press any dial keys within10 seconds after a voice guidanceprompt, the unit disconnects your call.Remote commandsYou can press dial keys to accesscertain answering system functionswithout waiting for the voice guidance toprompt you.*1 If pressed within the first 5 seconds ofa message, the previous message isplayed.Turning on the answeringsystem remotelyIf the answering system is off, you canturn it on remotely.1 Dial your phone number from atouch-tone phone.2 Let the phone ring 15 times.L A long beep is heard.3 Enter your remote access codewithin 10 seconds after the longbeep.L The greeting message is playedback.L You can either hang up, or enteryour remote access code againKey Operation1 Repeat message(during playback) *12 Skip message(during playback)4 Play new messages5 Play all messages6 Play greeting message7 Record greeting message9 Stop recordingStop playbackz Turn answering system off*4 Erase currently playingmessage*5 Erase all messages*6 Reset to a pre-recordedgreeting message (duringgreeting message playback)*y End remote operation(or hang up)TG862xAZ(e).book Page 46 Thursday, May 12, 2011 1:39 PM