“Telephone Plug-in” settingsSystem requirementsItem SpecificationsCPU 1.0 GHz Intel® Pentium®/Celeron®processor or comparable CPU orhigher processorRAM 512 MB or moreOS R Microsoft Windows® XPService Pack 3 or later (32-bitonly)R Microsoft Windows Vista®Service Pack 2 or laterR Microsoft Windows 7Service Pack 1 or laterMicrosoftOfficeOutlookR Microsoft Office Outlook 2003Service Pack 3 or laterR Microsoft Office Outlook 2007Service Pack 2 or laterR Microsoft Office Outlook 2010or later (Service Pack)Hard disk 20 MB or moreVideoresolution1,024 x 768 or higherOthers R CD-ROM driveR USB 2.0Trademarks:R Microsoft, Windows, Windows Vista, andOutlook are either registered trademarks ortrademarks of Microsoft Corporation in theUnited States and/or other countries.R Intel, Celeron and Pentium are trademarks ofIntel Corporation in the U.S. and other countries.R All other trademarks identified herein are theproperty of their respective owners.R Microsoft product screen shots reprinted withpermission from Microsoft Corporation.Note:R The screen shot shown is for Microsoft OfficeOutlook 2010.R The screen shots shown in these instructionsmay differ slightly from those of the actualproduct.R Software features and appearance are subjectto change without notice.Installing the “Telephone Plug-in”Before installing “Telephone Plug-in”, make sure ofthe following:– Microsoft Office Outlook is installed on yourcomputer.– The base unit is not connected to your computerwith the mini USB cable (until instructed to doso).1 Start Windows and exit all other applications.R You must be logged in as an administratorin order to install “Telephone Plug-in”.2 Insert the included CD-ROM into yourCD-ROM drive.R Installation starts automatically. If theinstallation does not start, see page 49.R For Microsoft Windows Vista andMicrosoft Windows 7 users:Click [Run Setup.exe] when prompted.3 When the language selection window isdisplayed, select the desired language andclick [Next].4 When the “Telephone Plug-in” window isdisplayed, click [Next].5 Read the license agreement carefully.If you accept the terms of the licenseagreement, check the box and click [Next].6 When the “Telephone Plug-in” install shieldwizard is displayed, click [Install].7 When installation is finished, click [Finish] tocomplete the installation. Then remove theCD-ROM from your CD-ROM drive.For assistance, please visit http://www.panasonic.com/help 19“Telephone Plug-in” for Microsoft Office Outlook