2 MbN: “Single Number” a MOKN3 MMENUN a MbN: “Add” a MOKN4 Enter the phone number (24 digits max.).R To erase a digit, press MCLEARN.5 MOKN a MOFFNStoring a range of numbers1 MMENUN#2172 MbN: “Range of Numbers” a MOKN3 MMENUN a MbN: “Add” a MOKN4 Enter the desired number (2-8 digits).R To erase a digit, press MCLEARN.5 MOKN a MOFFNBlocking incoming calls thathave no phone numberYou can block calls when no phone number isprovided, such as private callers.1 MMENUN#2402 MbN: Select the desired setting. a MOKN3 MOFFNViewing/editing/erasing callblock numbers1 MMENUN#2172 MbN: “Single Number” or “Range ofNumbers” a MOKN3 MbN: Select the desired entry.R To exit, press MOFFN.4 To edit a number:MEDITN a Edit the number. a MOKN aMOFFNTo erase a number:MERASEN a MbN: “Yes” a MOKN aMOFFNNote:R When editing, press the desired dial key toadd digits and press MCLEARN to erasedigits.Erasing all call block numbers1 MMENUN#2172 MbN: “Single Number” or “Range ofNumbers” a MOKN3 MMENUN a MbN: “Erase All” a MOKN4 MbN: “Yes” a MOKN5 MbN: “Yes” a MOKN a MOFFNBaby monitorThis feature allows you to listen in on a roomwhere another handset is located, allowingyou to easily monitor from different areas ofthe house or place. The monitored handset(placed in a baby’s room, for example) willautomatically call the monitoring handset orthe phone number stored when it detectssound.Important:R You should perform a test run of the babymonitor procedure to ensure that the babymonitor feature is set correctly. Forexample, test its sensitivity. Check theconnection if you are diverting the babymonitor to an outside line.R This feature should not be used as asubstitute for a medical or caregiver’ssupervision. It is the caregiver’sresponsibility to stay close enough tohandle any eventuality.Note:R Both the monitored and monitoringhandsets must select the same base unit inorder to use the baby monitor feature(page 35).R If the unit is connected to a PBX system,you cannot set the baby monitor.R During the monitoring mode, batteryconsumption is faster than usual. Werecommend leaving the monitored handseton the base unit or charger.R The monitored handset never rings while itis being monitored.KX-TGD320 series (page 3): If the baseunit is placed near the monitored handset,Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333 31ProgrammingTGD31x_32xE(en)0202_ver201.pdf 31 2015/02/02 14:00:40