Making cellular callsImportant:R The unit can be used to talk on 2 lines atthe same time (for example, 2 cellular lines,or the landline and 1 cellular line).R Only 2 Bluetooth devices can be used withthe unit at the same time (for example, 2cellular lines, or the headset and 1 cellularline*1).R Before making calls, confirm that thecorresponding on the handset isdisplayed (page 13).*1 You cannot use a Bluetooth headset totalk on a cellular line.1 Lift the handset and then dial the phonenumber.R To correct a digit, press MCLEARN.2 MCELLNR The unit starts dialing immediately inthe following situations.– Only 1 cellular phone is paired.– A specific line is set to make cellularcalls (page 19).Go to step 4.3 MbN: Select the desired cellular phone. aMSELECTN4 When you finish talking, press MOFFN orplace the handset on the base unit orcharger.Note:R To switch to the speaker, press MZN.To switch back to the receiver, press MZN/M N.R In step 1, you can store the dialed phonenumber to the phonebook by pressing andholding MFN W for a few seconds.Adjusting the receiver or speakervolumePress MDN or MCN repeatedly while talking.Note:R The receiver or speaker volume you set iskept for each line (landline and cellularlines).Making a cellular call using the rediallistThe last 5 phone numbers dialed are stored inthe redial list (48 digits max. each).1 MEN REDIAL2 MbN: Select the desired entry.3 MCELLNR The unit starts dialing immediately inthe following situations.– Only 1 cellular phone is paired.– A specific line is set to make cellularcalls (page 19).4 MbN: Select the desired cellular phone. aMSELECTNErasing a number in the redial listn When a cellular phone is paired:1 MEN REDIAL2 MbN: Select the desired entry. aMMENUN3 MbN: “Erase” a MSELECTN4 MbN: “Yes” a MSELECTN a MOFFNn When a cellular phone is not paired:1 MEN REDIAL2 MbN: Select the desired entry. aMERASEN3 MbN: “Yes” a MSELECTN a MOFFNMaking landline calls1 Lift the handset and then dial the phonenumber.R To correct a digit, press MCLEARN.2 Press M N to make the call.R To make the call using thespeakerphone, press MZN.3 When you finish talking, press MOFFN orplace the handset on the base unit orcharger.Note:R To switch to the speaker, press MZN.20 For assistance, visit www.panasonic.ca/english/supportMaking/Answering Calls