2 MbN: Select the desired setting. aMSAVENR If you select “Off”, press MOFFN toexit.3 Enter the desired hour and minute youwish to start this feature.4 *: Select “AM” or “PM”. a MOKN5 Enter the desired hour and minute youwish to end this feature.6 *: Select “AM” or “PM”.7 MSAVEN a MOFFNChanging the start and end time1 MMENUN#2372 Continue from step 3, “Turning nightmode on/off”, page 39.Selecting groups to bypass nightmode1 MMENUN#2412 MbN: Select the desired groups. aMSELECTNR “ ” is displayed next to the selectedgroup numbers.R To cancel the selected group:MbN: Select the group. a PressMSELECTN again. “ ” disappears.3 MSAVEN a MOFFNOther programmingChanging the handset nameThe default handset name is “Handset 1” to“Handset 6”. You can customize the nameof each handset (“Bob”, “Kitchen”, etc.). This isuseful when you make intercom calls betweenhandsets. To display the handset name instandby mode, turn on the handset namedisplay feature (page 40).1 MMENUN#1042 Enter the desired name (10 charactersmax.). a MSAVEN a MOFFNDisplaying the handset nameYou can select whether or not the handsetname is displayed in standby mode. Thedefault setting is “Off”.1 MMENUN#1052 MbN: Select the desired setting. aMSAVEN a MOFFNRegistering a unitOperating additional unitsAdditional handsetsUp to 6 handsets can be registered to thebase unit.Important:R See page 4 for information on the availablemodel.Registering a handset to thebase unitThe supplied handset and base unit arepre-registered. If for some reason the handsetis not registered to the base unit, re-registerthe handset.1 Handset:MMENUN#1302 Base unit:Press and hold MLOCATORN for about 5seconds.R If all registered handsets start ringing,press MLOCATORN again to stop, thenrepeat this step.3 Handset:Press MOKN, then wait until a long beepsounds.Deregistering a handsetA handset can cancel its own registration tothe base unit, or other handsets registered tothe same base unit. This allows the handset toend its wireless connection with the system.40 For assistance, visit www.panasonic.ca/english/supportProgramming