Panasonic KX-TGD590C Operating Instructions Manual

Also see for KX-TG273CSK: Quick guide

Contents

Display message Cause/solutionMain unitno powerorNo link. Re-connect baseAC adaptor.R Confirm the base unit’s AC adaptor is connected tothe unit and the power outlet correctly.R The handset has lost communication with the baseunit. Move closer to the base unit and try again.R Unplug the base unit’s AC adaptor to reset the unit.Reconnect the adaptor and try again.R The handset’s registration may have been cancelled.Re-register the handset (page 40).Requiressubscriptionto Caller ID.R You must subscribe to a Caller ID service. Once youreceive caller information after subscribing to a CallerID service, this message will not be displayed.Userechargeablebattery.R A wrong type of battery such as alkaline ormanganese was inserted. Use only the rechargeableNi-MH batteries noted on page 4, 8.TroubleshootingIf you still have difficulties after following the instructions in this section, disconnect the base unit’sAC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset,and then insert them into the handset again.General useProblem Cause/solutionThe handset does not turn oneven after installing chargedbatteries.R Place the handset on the base unit or charger to turn onthe handset.The unit does not work. R Make sure the batteries are installed correctly (page 10).R Fully charge the batteries (page 11).R Check the connections (page 10).R Unplug the base unit’s AC adaptor to reset the unit.Reconnect the adaptor and try again.R The handset has not been registered to the base unit.Register the handset (page 40).For assistance, visit www.panasonic.ca/english/support 61Useful Information