TimeProblem Cause/SolutionThe time is not correct. • Adjust the date and time of the unit. For details about theoperations, refer to the User Guide on the Panasonic Website (® see Introduction).• In the Web user interface, you can set NTPsynchronization and DST (Summer Time) control to adjustthe time automatically (® see 3.5.5 Time AdjustSettings).• If the time is still incorrect even after setting NTPsynchronization, check the firewall and port forwardingsettings on the router (® see 1.1.10 Other NetworkSettings).Checking the Status of the UnitYou can check the status of the unit by using Web user interface programming (® see 3.3.2 NetworkStatus and 3.3.3 VoIP Status) or by looking at system logs (® see 4.3.3 Syslog Settings) sent from theunit.To check the setting status in the Web user interface1. Click the [Status] tab, and then click [Network Status] to check the network settings.2. Check the status displayed.3. Click [VoIP Status] to check the VoIP settings.4. Check the status displayed.To send the system logs of specified events to the syslog server1. Set the following parameters to specify your PC (Windows, Linux® operating system, etc.) as the syslogserver:– SYSLOG_ADDR: Specifies the IP address or FQDN of the syslog server.– SYSLOG_PORT: Specifies the port number of the syslog server.2. Set the following parameters to log specific events:– SYSLOG_EVENT_SIP*1: Logs SIP-related syslog events.– SYSLOG_EVENT_CFG*1: Logs syslog events regarding configuration.– SYSLOG_EVENT_VOIP*1: Logs syslog events regarding VoIP operation.– SYSLOG_EVENT_TEL*1: Logs syslog events regarding telephone functions.*1 In this version of the unit, this system log will not be sent.228 Administrator Guide Document Version 2011-017.1 Troubleshooting
