INTEGRATING THE VPS WITH THE PANASONIC KX-TA SERIES PBX AND KX-TD SERIES PBXInstallation Manual 1074.5.10 Two-Way Transfer Button Assignment via StationProgrammingFor the Two-Way Transfer feature to work at an extension, the extension must have a TWTbutton on it. This key must either be a DSS/BLF or CO key with a lamp. Follow the procedurebelow to assign a TWT button on an extension. (This is a station level program and should bedone at each individual telephone.)PC programming is also available for KX-TD500 users (see 4.5.12 Button Assignment viaPC Programming).1. Enter PITS Programming:For KX-TA624With the phone on-hook, Set the MEMORY switch to "PROGRAM".(Display changes to PITS-PGM Mode.)For KX-T series PBX that uses DPT Integrationa. With the phone on-hook, Press the PROGRAM button.b. Dial [99]. (Display changes to PITS-PGM Mode.)2. Press the desired FLEXIBLE (CO or DSS/BLF) button that you want to assign as theTWT button.3. Dial [91].Screen output: 2Way-Trans:4. Dial the Voice Mail extension number.Screen output: 2Way-Trans: _ _ _(_ _ _ = The extension number you entered).5. Press STORE.6. For KX-TA624Set the MEMORY switch to "SET".For KX-T series PBX that uses DPT IntegrationPress the PROGRAM button or lift the handset.7. Repeat these steps for each telephone.Conditions: This button must be a CO or DSS/BLF key to beprogrammed as a TWR button. If this key is pressedwhen all Voice Mail ports are busy, the user will hear areorder tone.Conditions: This button must be a CO or DSS/BLF key to beprogrammed as a TWT button. When all Voice Mailports are busy and this key is pressed, the user will hearreorder tone.
