INTEGRATING THE VPS WITH PANASONIC KX-T PHONE SYSTEMSInstallation Manual 51b) If the VPS is only answering calls not answered by the operator (Operator Backup):Flexible Ringing Assignment—For each outside (CO) line, use System Programs[47] (Day Mode) and [48] (Night Mode) to enable ringing at the operator’s extension(jack).Delayed Ringing Assignment—To give the operator time to answer the call beforethe VPS picks up, we recommend setting the delay to 3 or 4 rings for each extensionconnected to the VPS. Use System Programs [49] (Day Mode) and [50] (NightMode).Outside (CO) Line Mode—Set the mode for each outside (CO) line to "Normal".Use System Programs [51] and [52] to set this parameter.c) If the VPS is only answering calls not answered by user extensions:Flexible Ringing Assignment—For each outside (CO) line, use System Programs[47] (Day Mode) and [48] (Night Mode) to enable ringing on every extension (jack)that you want to have ring.Delayed Ringing Assignment—To give users time to answer the call before theVPS picks up, we recommend setting the delay to 3 or 4 rings for each extensionconnected to the VPS. Use System Programs [49] (Day Mode) and [50] (NightMode).CO Mode—Set the mode for each outside (CO) line to "Normal". Use SystemPrograms [51] and [52] to set this parameter.3.3.3 KX-TA Series Programming for Inband Integration via theManager’s ExtensionNoteIf your PBX is the KX-TA1232, please refer to the procedure described in 3.3.5 KX-TD816, KX-TD1232, KX-TA1232 and KX-TD308 Programming for Inband Integration viathe Manager’s Extension or 3.3.6 KX-TD816, KX-TD1232, and KX-TA1232 Programmingfor Inband Integration via the Operating and Maintenance Tool for programming.1. Enable System Program [102] for each extension connected to the VPS. Jack 07, or jacks07 and 08 can be assigned for the VPS1 as the Voice Mail port. Jack 15, or jacks 15 and 16can be assigned for the VPS2.This parameter is used to tell the KX-TA series which extensions are connected to the VPS.Ports with this parameter enabled can receive Follow-on ID and touchtone call statusSignaling (busy, answered, disconnect, etc.) if the Voice Mail integration and TouchtoneIntegration features are also enabled.2. Enable System Program [103] to turn on Touchtone Integration. On extensions with theVoice Mail port parameter enabled, the KX-TA series can send codes (touchtones) toindicate call states; this increases VPS efficiency. Codes apply to all transferred calls;outside calls only indicate disconnect (provided the KX-TA series is programmed for CPCDetection, and the Central Office sends the CPC signal). Refer to the Table 10 in Section3.2.4 PBX Interface Parameters.
