1.1.6.2 Changing the Language for Web User Interface ProgrammingWhen accessing the unit via the Web user interface on a PC connected to the same network, various menusand settings are displayed. You can change the language used for displaying these setting items. Becausethe language setting for the Web user interface is not synchronized with those of the unit, you must set thelanguages for each independently.For details, see 4.4.1 Web Language.1.1.6.3 Before Accessing the Web User InterfaceRecommended EnvironmentThis unit supports the following specifications:HTTP Version HTTP/1.0 (RFC 1945), HTTP/1.1 (RFC 2616)Authentication Method Digest (or Basic)The Web user interface will operate correctly in the following environments:Operating System Microsoft® Windows® XP or Windows 7 operating systemWeb Browser Internet Explorer® 7.0, or Internet Explorer 8.0 internet browserLanguage (recommended) EnglishOpening/Closing the Web PortTo access the Web user interface, you must open the unit’s Web port beforehand. For details, refer to theOperating Instructions on the Panasonic Web site (® see Introduction).For details about additional features available with direct commands, see Section 3 Phone User InterfaceProgramming.Configuring Settings from the UnitTo open the unit’s Web port1.Setting (soft button) ® [#][5][3][4]2. [ ]/[ ]: Select "On" for "Embedded web" ® [ENTER]To close the unit’s Web port1.Setting (soft button) ® [#][5][3][4]2. [ ]/[ ]: Select "Off" for "Embedded web" ® [ENTER]20 Administrator Guide Document Version 2011-061.1.6 Web User Interface Programming
