Tone TimingsDescription Specifies the pattern, in milliseconds, of dial tones using up to 10 wholenumbers (off 1, on 1, off 2, on 2…) separated by commas.Note• The unit will not play the tone for the duration of the first value,play it for the duration of the second value, stop it for theduration of the third value, play it again for the duration of thefourth value, and so on. The whole sequence will then repeat.For example, if the value for this setting is "100,100,100,0", theunit will not play the tone for 100 ms, play it for 100 ms, stop itfor 100 ms, and then play it continuously.• It is recommended that you set a value of 60 milliseconds ormore for the first value (off 1).Value Range 1–60 characters0–16000 (0: Infinite time)Note• Avoid setting 1–50 for any of the values.Default Value 60,0Configuration File Reference DIAL_TONE1_TIMING (Page 265)4.6.6.2 Busy ToneTone FrequenciesDescription Specifies the dual-tone frequencies, in hertz, of busy tones using 2whole numbers separated by a comma.Value Range 1–9 characters0, 200–2000 (0: No tone)Default Value 480,620Configuration File Reference BUSY_TONE_FRQ (Page 266)Tone TimingsDescription Specifies the pattern, in milliseconds, of busy tones using up to 10whole numbers (off 1, on 1, off 2, on 2…) separated by commas.Note• It is recommended that you set a value of 60 milliseconds ormore for the first value (off 1).Value Range 1–60 characters0–16000 (0: Infinite time)Note• Avoid setting 1–50 for any of the values.148 Administrator Guide Document Version 2014-054.6.6 Tone Settings
